6. Select a wash temperature with the WASH TEMPERATURE
selector. The selections are color-coordinated with the cycles
on the Cycle Control knob so you can select a water Washer Symbols
temperature that matches the type of fabric and soils being The control panel of your washer contains symbols. Refer to the
washed. Follow garment label instructions.chart below for a definition of those symbols.
SymbolsSymbols
Small LoadHand Washables
Large LoadSuper Wash
Your washer uses automatic temperature control (on some
models) to maintain a uniform water temperature by
regulating the incoming hot and cold water. This helps ColdWash
eliminate undissolved detergent and ensures consistent Temperature
cleaning results. The cold wash is regulated at approximately
75°F (24°C) by adding small amounts of hot water during the
cold fill. The warm wash is maintained at approximately WarmQuick Wash
100°F (38°C).Temperature
NOTE: Make sure that both the hot and cold water taps are
fully turned on or the automatic temperature control feature HotPrewash
will not work properly.Temperature
Water TempUse ForTemperatureRinse
HotWhites and pastels
111°F (44°C)Heavy and greasy soils
or aboveOnExtra Rinse
WarmBright colors
90°-110°F
Moderate to light soils
(32°-43°C)OffSpin
ColdColors that bleed or fade
70°-90°F Light soils
(21°-32°C)BuzzerSlow Spin
NOTE: In wash water temperatures colder than 70oF
(21oC), detergents do not dissolve well. Soils can be difficult CottonCool Down
to remove. Some fabrics can retain wear wrinkles and have
increased pilling (the formation of small lint-like balls on the
surface of garments).
SyntheticsPull Start
7. (OPTIONAL) For an additional rinse and spin at the end of a Push Stop
wash cycle, set the EXTRA RINSE selector to ON.
8. Push in the Cycle Control knob and turn it clockwise to the
wash cycle you want. Reduce the wash time when using a Delicates
small load size setting. See ?Selecting a Cycle, Time, and
Temperature?.
Pull out the Cycle Control knob to start the washer.
To stop or restart your washer
nTo stop the washer at any time, push in the Cycle Control
knob.
nTo restart the washer, close the lid (if open) and pull out the
Cycle Control knob.
7 |
ACEC
