Assembling Your Bowl-Lift Mixer
To Attach Bowl
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
3. Place bowl-lift handle in down
Pin
position.
4. Fit bowl supports over locating pins.
5. Press down on back of bowl until
4. Turn beater to left, hooking beater
bowl pin snaps into spring latch.
over the pin on shaft.
6. Raise bowl before mixing.
5. Plug into a grounded 3 prong
7. Plug into a grounded 3 prong
outlet.
outlet.
To Remove Flat Beater,
Wire Whip, or PowerKneada
Spiral Dough Hook
1. Turn speed control to OFF.
2. Unplug Stand Mixer or disconnect
power.
Raise3. Press beater upward and turn
right.
To Raise Bowl4. Pull beater from beater shaft.
1. Rotate handle to straight-upHousehold Stand Mixer
position.Speed Control
2. Bowl must always be in raised,
RESET
locked position when mixing. OFF/02 4 6 8 10STIR
To Lower Bowl
1. Rotate handle back and down.
Plug into a grounded 3 prong outlet.
To Remove BowlSpeed control lever should always be
set on lowest speed for starting, then
1. Turn speed control to OFF.
gradually moved to desired higher
2. Unplug Stand Mixer or disconnect
speed to avoid splashing ingredients
power.
out of bowl. See page 9 for Speed
3. Place bowl-lift handle in down
Control Guide.
position
4. Remove flat beater, wire whip, orAuto-Reset Motor Protection
spiral dough hook.
If the Stand Mixer stops due to
5. Grasp bowl handle and lift straight
overload, slide the speed control
up and off locating pins.
lever to OFF. After a few minutes,
To Attach Flat Beater, the stand mixer will automatically
Wire Whip, or PowerKneadareset. Slide the Speed Control Lever
Spiral Dough Hookto the desired speed and continue
mixing. If the unit does not restart,
1. Turn speed control to OFF.
see OTroubleshooting� on page 14.
2. Unplug Stand Mixer or disconnect
power.
3. Slip flat beater on beater shaft.
5 |
ACEC
