Care and Maintenance
To reassemble:
1. After cleaning, align the keyed
burr-shaft assembly with the motor
shaft. Lower the burr-shaft assembly
onto the motor shaft and rotate
until the burr-shaft assembly falls
into place inside the motor housing.
4. Turn the grind-adjustment ring
counterclockwise several complete
rotations, and remove it from the
base.
2. Place the grind-adjustment ring
onto the motor housing. Press and
turn the grind-adjustment ring
clockwise several rotations until the
gear offers complete resistance,
then rotate it counterclockwise
5. Lift the burr-shaft assembly out ofuntil the selection arrow aligns
the motor housing.with the initial OM� for the
6. Using the cleaning tool, clean theMedium grind selection.
burr mounted on the burr-shaft
assembly and the burr mounted
underneath the grind-adjustment
ring.
3. Replace the set screw and tighten
with the Phillips-head screwdriver.
Your Coffee Mill is now ready
for use.NOTE: Never wash the burrs or burr-
shaft assembly in water. Keep them
dry at all times.
9 |
ACEC
