Assembling Your Tilt-Head Mixer
5. Slip beater
s
onto beater foreinsertingofremovingpart
8 10CAUTION:Unplugbe
shaft and ResetStir
Off/O 2 4 6
press upward
as far as
pin
possible.
6. Hook beater over pin on shaft by
offon
turning clockwise (right).
7. Unlock motor head and lower.
8. Lock motor head and plug into a
grounded 3 prong outlet.
To Attach Bowl
To Remove flat Beater, Wire Whip
1. Turn speed control to OFF.or dough Hook
2. Unplug Stand Mixer or
1. Turn speed control to OFF.
disconnect power.
2. Unplug Stand Mixer or
3. Unlock motor head.
disconnect power.
4. Tilt motor head back and lock.
3. Unlock motor head.
5. Place bowl on bowl lock plate.
4. Tilt motor head back and lock.
6. Turn bowl gently in clockwise
flat Beater5. Press beater upward as far as
direction.
possible and turn counterclockwise
7. Lower motor head and lock.
(left) to unhook.
8. Plug into a grounded 3 prong
6. Pull beater from beater shaft.
outlet.
7. Unlock motor head and lower.
To Remove Bowl
1. Turn speed control to OFF.
2. Unplug Stand Mixer or
disconnect power.
3. Unlock motor head.
4. Tilt motor head back and lock.
5. Turn bowl in counterclockwise
direction and remove.
6. Lower motor head and lock.To lock Motor Head
To Attach flat Beater, Wire Whip, 1. Push locking lever back as far
or dough Hookas possible.
2. Test lock by attempting to raise or
1. Turn speed control to OFF.
lower head.
2. Unplug Stand Mixer or disconnect
noTe: Motor head should always be
power.
locked when using mixer, and when
3. Unlock motor head.
attaching or removing the bowl, flat
4. Tilt motor head back and lock.
beater, wire whip, or dough hook.
When in locked position, lever may not
extend all the way back. This is normal.
To unlock Motor Head
1. Pull locking lever forward as far as
possible. Motor head can now be
raised or lowered.
5 |
ACEC
