Removing the base grille
To remove the grille: Condenser coils
1. Open refrigerator door.
2. Pull base grille forward to release the
support tabs from the metal clips.
3. Do not remove Tech Sheet fastened
behind the grille.
To replace the grille:
1. Line up grille support tabs with metal
clips.
2. Push firmly to snap into place.
3. Close refrigerator door.
See cleaning instructions for defrost pan and
condenser coils on page 15.
Reversing the door swing
You can change the hinges on your refrig-
erator so the doors open the other way.
Refer to the instruction sheet included with
your refrigerator.
Understanding the sounds you may hear
Your new refriqerator may make sounds that Water sounds
your old one didn?t. Because the sounds are When the refrigerator stops running, you
new to you, you might be concerned about
them. Don?t be. Most of the new sounds are may hear gurgling in the tubing for a few
normal. Hard surfaces like the floor, walls minutes after it stops. You may also hear
and cabinets can make the sounds seem defrost water running into the defrost water
pan.
louder.
The following describes the kinds of Running sounds
sounds that might be new to you, and what Your refrigerator has a high-efficiency
may be making them. compressor and motor. It will run longer than
Slight hum, soft hiss older designs. It may even seem to run most
You may hear the refrigerator?s fan motor of the time.
and moving air.
Clicking or snapping sounds
The thermostat makes a definite click when
the refrigerator stops running. It also makes
a sound when the refrigerator starts. The
defrost timer will click when the defrost cycle
starts.
12 |
ACEC
