arb
Assembling Your 5 Quart Mixer
TO ATTACH BOWLTO ATTACH FLAT BEATER,
1. Be sure speed control is OFF andWIRE WHIP, OR DOUGH HOOK
mixer is unplugged.1. Turn speed control to OFF and
unplug.
2. Place bowl lift handle in down
position.2. Slip flat beater on beater shaft and
press upward as far as possible.
3. Fit bowl supports over locating pins.
3. Turn beater to
4. Press down on back of bowl until
right, hooking
bowl pin snaps into spring latch.
beater over the
5. Raise bowl before mixing.PIN
pin on shaft.
**
6. Plug mixer in proper electrical outlet.**
4. Plug mixer in proper electrical outlet.
TO REMOVE BOWL
TO REMOVE FLAT BEATER,
1. Be sure speed control is OFF and
WIRE WHIP, OR DOUGH HOOK
mixer is unplugged.
1. Turn speed control to OFF and
2. Place bowl lift handle in downunplug.
position
2. Press beater upward as far as
3. Remove flat beater, wire whip, orpossible and turn left.
dough hook.
3. Pull beater from beater shaft.
4. Grasp bowl handle and lift straight**
4. Plug mixer in proper electrical outlet.
up and off locating pins.
Solid State Speed Control
Off Stir 2 4 6 8 10
HOUSEHOLD MIXER
SPEED CONTROL
RAISE**
Plug mixer in proper electrical outlet.
Speed control lever should always to be
set on lowest speed for starting, then
TO RAISE BOWL
gradually moved to desired higher speed
1. Rotate handle to straight-up position.
to avoid splashing ingredients out of bowl.
2. Bowl must always be in raised,See pages 14, 18 for Speed Control Guide.
locked position when mixing.
OVERLOAD RESET BUTTON
TO LOWER BOWL
CModels KSM50P and
1. Rotate handle back and down.Overload Reset
KSMC50 only
ý
If the mixer is overloaded,
!WARNING
the Overload Reset Button
will pop out and the mixer will shut off.
Injury Hazard
Turn the Speed Control Lever to OFF.
Unplug mixer before inserting
Wait a few minutes, then push in the
or removing beaters.
Reset Button. Turn the Speed Control
Unplug mixer before cleaning.
Lever to the desired speed and continue
Failure to do so can result in
mixing.
broken bones or cuts.
** See page 6.
9 |