Items should move easily through the wash water.
Overloading can cause poor cleaning.
Starting Your Washer
To reduce wrinkling of permanent press clothes and some
synthetic knits, use a large load size to provide more space
(see step 5).
2. (OPTIONAL) Pour measured liquid bleach into the liquid
bleach dispenser. Bleach will be dispensed automatically
during the wash part of the cycle.
Fire Hazard
Never place items in the washer that are
dampened with petrol or other flammable fluids.Never use more than 250 mL (1 cup) for a full load. Use
less with a smaller load size.
No washer can completely remove oil.
Follow the manufacturer?s directions for safe use.
Do not dry anything that has ever had any type of To avoid spilling, use a cup with a pouring spout. Do not
oil on it (including cooking oils).let bleach splash, drip, or run down into the washer
basket.
Doing so can result in death, explosion, or fire.
Use only liquid bleach in this dispenser.
3. Close the washer lid.
4. Turn the LOAD SIZE selector to the correct setting for your
wash load and the type of fabric being washed.
WARNING
Choose a load size that allows the load to move freely for
best fabric care. See "Loading."
You may change the load size selection after the washer
has started filling by turning the selector to a different
Electrical Shock Hazard
setting.
Plug into an earthed plug socket outlet.
5. Set the TEMPERATURE selector to the correct setting for the
Do not remove earth pin.type of fabric and soils being washed. Use the warmest water
safe for fabric. Follow garment label instructions.
Do not use an adaptor.
Your washer uses automatic temperature control to maintain
Do not use an extension cord.
a uniform water temperature by regulating incoming hot and
Failure to follow these instructions can result incold water. This helps eliminate undissolved detergent and
ensures consistent cleaning results. The cold wash is
death, fire, or electrical shock.
regulated at approximately 24oC (75oF) by adding small
amounts of hot water during the cold fill. The warm wash is
1. Measure detergent and pour it into the washer. If desired, add maintained at approximately 38oC (100oF).
powdered or liquid colour safe bleach. If the water
NOTE: Make sure that both hot and cold water taps are fully
temperature is too low, dilute the detergent in warm water.
turned on, or the automatic temperature control feature will
Add extra detergent for the Super Wash cycle. Follow
not work properly.
detergent manufacturer?s directions.
Water TempUse For
HotWhites and pastels
44°C (111°F)
Heavy soils
or above
WarmBright colours
32°-43°C
Moderate to light soils
Drop a sorted load of clothes loosely into your washer.(90°-110°F)
Load evenly to maintain washer balance. Mix large and small
ColdColours that bleed or fade
items. Larger items such as sheets should be added last.
21°-32°C
Light soils
(70°-90°F)
6 |
ACEC
