Check for leaks
Turn on the water taps and check for leaks. A small amount of water might enter the washer. Complete Installation
You will drain this later.
1. Check the electrical requirements. Be sure that you have the correct electrical supply and
NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose the recommended earthing method. See Electrical Requirements.
installation or replacement dates for future reference.2. Check that all parts are now installed. If there is an extra part, go back through the steps to
 If you connect only one water hose, you must cap off the remaining water inlet port.see which step was skipped.
 Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found.3. Check that you have all of your tools.
4. Check that the yellow shipping strap was completely removed from the lower back of the
washer.
Secure the Drain Hose
5. Dispose of/recycle all packaging materials.
1. Remove the shipping material from the power cord. Drape the power cord over the
console.6. Check that the water taps are on.
7. Check for leaks around taps and inlet hoses.
2. Remove any cardboard used to move washer.
WARNING
Beaded tie strap
3. Wrap the drain hose to the laundry tub leg, drain standpipe or inlet hoses, with the
beaded tie strap. Push fastener into the nearest hole in the beaded tie strap. See view A or
B.Electric Shock Hazard
Electrically earth this appliance.
Do not use an extension cord or an electrical portable
outlet device.
Failure to follow these instructions can result in death,
fire or electric shock.
8. Plug into an earthed outlet.
9. Remove the protective film on the console and any tape remaining on the washer.
10. Read Washer Use.
ABC11. To test and to clean your washer, measure 1? of the normal recommended amount of
powdered or liquid detergent and pour it into the washer basket or detergent dispenser
If the washer taps and the drain standpipe are recessed, put the formed end of the drain (on some models). Close the lid. Select any cycle, and then pull the Cycle Control knob
hose into the standpipe. Tightly wrap the tie strap around the water inlet hoses and the out to start the washer. Allow it to complete one whole cycle.
drain hose. See view C.
12 |
ACEC
