REFRIGERATOR FEATURES
Your model may have some or all of these features. Features that
can be purchased separately as product accessories are labeled Convertible Vegetable/Meat Drawer,
with the word ?Accessory.? Not all accessories will fit all models.
If you are interested in purchasing one of the accessories, please Crisper and Covers
call the toll-free number on the back cover or in the (on some models)
?Accessories? section.
Crisper and Convertible Vegetable Meat Drawers
Important information to know about glass shelves
and covers:To Remove and Replace Drawers:
Do not clean glass shelves or covers with warm water when 1. Slide crisper or meat drawer straight out to the stop. Lift the
they are cold. Shelves and covers may break if exposed to front of drawer with one hand while supporting the bottom of
sudden temperature changes or impact, such as bumping. drawer with other hand and slide the drawer out the rest of
the way. For your protection, tempered glass is designed to shatter
into many small, pebble-size pieces. This is normal. Glass 2. Replace the crisper or meat drawer by sliding it back in fully
shelves and covers are heavy. Use special care when past the drawer stop.
removing them to avoid impact from dropping.
Crisper or Vegetable/Meat Drawer Covers
To Remove and Replace Covers:
Refrigerator Shelves1. Remove the crisper and meat drawers. Press up in center of
Your model may have glass or wire shelves. Store similar foods crisper glass insert until it rises above the plastic frame.
together and adjust the shelves to fit different heights. This Holding the crisper glass firmly, slide the glass insert forward
reduces the time the refrigerator door is open and saves energy.to remove.
2. Lift crisper cover frame and remove. Repeat steps to remove
Shelves and Shelf Frames (Fixed and Slide-out)the meat drawer cover.
To Remove and Replace a Shelf:
1. Pull the shelf forward to the stop. Tilt the front of the shelf up.
Lift to remove from the shelf supports.
2. Replace the shelf/frame by aligning the shelf with the shelf
supports. Slide the shelf onto the shelf supports. Be sure that
the shelf is securely in position.3. Replace back of meat drawer cover frame into supports or
slides on side walls of the refrigerator and lower or slide the
front of the cover frame into place.
4. Slide rear of glass insert into cover frame and lower front into
place. Repeat steps to replace the crisper cover.
Wine Rack
(on some models - Accessory)
Deli BinTo Install and Remove the Wine Rack:
The deli drawer stores raisins, nuts, spreads, and other small 1. Install the wine rack by aligning it with the three shelf tabs
items at normal refrigerator temperatures.located on the bottom of the shelf. Pull the wine rack straight
To Remove and Replace the Deli Bin: down until it locks onto the shelf tabs as shown.
1. Remove the deli bin by sliding it straight out to the stop. Lift
the front and back of the bin up and out of the shelf supports.
Tilt the bin sideways to remove from the refrigerator
compartment.
2. Replace the deli bin by sliding it back past the stop and
pushing into place.
2. To remove the wine rack, lift it straight up and off the shelf
tabs.
Utility Bin
(on some models - Accessory)
NOTE: For long-term storage, place eggs in a covered container
or in their original carton on an interior shelf.
40 |
ACEC
