Loading
WASHER USE
Loading suggestions
For these suggested full-sized loads, set the LOAD SIZE selector
to the highest load size setting.
Understanding Washer Cycles
SUPER CAPACITY WASHERS
When the Cycle Control knob is set to a number and pulled out,
the washer fills (to the selected load size) before agitation and
Heavy Work Clothes
timing start. The washer begins agitating immediately after filling;
3 pair pants1 coverall
agitation occurs with the washer lid up or down.
3 shirts1 overall
During agitation, the agitator creates a continuous rollover action 4 pair jeans
(on some models) that provides a thorough cleaning of the wash
load.Delicates
3 camisoles2 bras
1 quilted robe2 nighties
4 slips1 baby?s dress
4 panties
Towels
10 bath towels14 wash cloths
10 hand towels1 bath mat
After agitation starts, the Cycle Control knob turns clockwise until
it points to an OFF area and the cycle ends.
Mixed Load
NOTE: The washer pauses briefly throughout each cycle. These 3 double sheets2 shirts
pauses are normal for washer operation.4 pillowcases2 blouses
8 T-shirts8 handkerchiefs
WASHRINSE6 pair shorts
1. Fill1. Fill
EXTRA LARGE CAPACITY WASHERS
Heavy Work Clothes
2 pair pants3 pair jeans
2. Wash2. Rinse3 shirts1 coverall
selected
timeDelicates
3 camisoles2 bras
4 slips2 nighties
?
3. Drain3. Drain4 panties
No agitation No agitation
Towels
8 bath towels10 wash cloths
8 hand towels1 bath mat
4. Spin4. Spin-Spray
rinse
Mixed Load
2 double sheets or6 pair shorts
1 king size sheet2 shirts
4 pillowcases2 blouses
5. Spin
6 T-shirts6 handkerchiefs
?Normal Washer Sounds
The Casual/Permanent Press 6. Off
cycle partially drains,
Your new washer may make sounds your old one didn?t. Because
fills, agitates briefly, and
the sounds might be unfamiliar, you may be concerned about
drains.
them. These sounds are normal.
During washing
When you select a small load size setting, your washer has a
lower water level. This can cause a clicking sound from the upper
part of the agitator.
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you may hear
gears engaging.
5 |
ACEC
