It is normal for the ice cubes to be attached at the corners.
Style 2They will break apart easily.
For Style 1 ice maker, do not force the wire shutoff arm up or
To Turn the Ice Maker ON/OFF: down.
The ON/OFF switch is located on the top right side of the freezer
compartment.Do not store anything on top of the ice maker or in the ice
1. To turn the ice maker on, slide the control to the ON (left) storage bin.
position.
NOTE: Your ice maker has an automatic shutoff. The ice
maker sensors will automatically stop ice production, but the REFRIGERATOR FEATURES
control will remain in the ON (left) position.
Your model may have some or all of these features. Features that
2. To manually turn the ice maker off, slide the control to the can be purchased separately as accessories are labeled with the
OFF (right) position.word ?Accessory.? Not all accessories will fit all models. If you are
interested in purchasing one of the accessories, please call the
toll-free number on the cover or in the ?Accessories? section.
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter
To Remove and Replace the Ice Storage Bin:into many small, pebble-size pieces. This is normal. Glass
1. Hold the base of the storage bin with both hands and press shelves and covers are heavy. Use special care when
the release button to lift the storage bin up and out. removing them to avoid impact from dropping.
NOTE: It is not necessary to turn the ice maker control to the
OFF (right) position when removing the storage bin. The
sensor cover (?flipper door?) on the left wall of the freezer
stops the ice maker from producing ice if the door is open or Refrigerator Shelves
the storage bin is removed. Your model may have glass or wire shelves. Store similar foods
together and adjust the shelves to fit different heights. This
2. Replace the storage bin on the door and push down to make
sure it is securely in place.reduces the time the refrigerator door is open and saves energy.
Slide-out Shelves (on some models)
To Remove and Replace a Shelf in a Metal Frame:
1. Pull the shelf forward to the stop. Tilt the front of the shelf up
and lift it slightly as you pull the shelf from the frame.
2. Replace the shelf by guiding it back into the slots on the
frame and pushing the shelf in past the stop.
Clean the Ice Storage Bin
1. Empty the ice container. Use warm water to melt the ice if
necessary.
NOTE: Never use anything sharp to break up the ice in the
bin. This can cause damage to the ice container and the
dispenser mechanism.
2. Wash ice bin with a mild detergent, rinse well and dry
Shelves and Shelf Frames
thoroughly. Do not use harsh or abrasive cleaners or solvents.
REMEMBER:To Remove and Replace a Shelf/Frame:
1. Remove the shelf/frame by tilting it up at the front and lifting it
Allow 24 hours to produce the first batch of ice. Allow 3 days out of the shelf supports.
to completely fill ice container.
2. Replace the shelf/frame by guiding the rear shelf hooks into
Discard the first three batches of ice produced to avoid the shelf supports. Tilt the front of the shelf up until rear shelf
impurities that may be flushed out of the system.hooks drop into the shelf supports. Check to make sure that
the shelf is securely in position.
The quality of your ice will be only as good as the quality of
the water supplied to your ice maker.
Avoid connecting the ice maker to a softened water supply.
Water softener chemicals (such as salt) can damage parts of
the ice maker and lead to poor quality ice. If a softened water
supply cannot be avoided, make sure the water softener is
operating properly and is well maintained.
13 |
ACEC
