Installation
To Install:
Opening and Closing Your
1. Align drawer handle clips to the left of the studs
attached to the freezer drawer.Fresh Food Doors select models
Your new refrigerator is uniquely
2. Ensure the large hole in the mounting clip is
designed with two fresh food doors.Vertically
positioned to the right on both ends of the handle.
Hinged Seal
Either door can be opened or closed
3. Rotate the handle so the left base is flat against
independently of one another.
the door.
There is a vertically-hinged section
4. Grasp the handle firmly and slide handle to the
on the left fresh food door. When
right.
the left door is closed, the hinged
section automatically forms a seal
HandleDoor
between the two doors when both
ClipStud
doors are closed.
When the left door is opened, the hinged seal
automatically folds inward so that it is out of the way.
WARNING
To avoid electrical shock which can cause severe
personal injury or death, DO NOT attempt to
remove the hinged seal from the fresh food
To Remove:
section.
1. With both hands, firmly grasp the handle toward
CAUTION
the right side.
To avoid possible product damage, ALWAYS verify
2. Slide toward the left, lift and remove from the
that the hinged seal is folded against the edge of
surface.
the door prior to closing.
How to Connect the Water
Supply select models
WARNING
Handle RemovalContact a qualified engineer to perform this task.
Euro Handles
Ice Maker Operation
This handle style is installed at the factory
Y To turn ice maker On push arm down from locked
position.
Materials Needed:
3
Y�32�Allen wrench
To Remove:
Y Remove set screw from handle
3
mounting post using �32�Allen
wrench.
Y Lift arm up and lock into position to turn ice maker
Y Repeat the procedure on all posts
Off.
to remove the handle.
To Replace:
Y Align handle with the mounting posts.
Y Fully tighten all set screws to secure handle
in place.
6 |
ACEC
