Installation
To Install:
Pullout Freezer Drawer
1. Pull both rails out to full
select models
extension.
DANGER
To prevent accidental child entrapment or
suffocation risk, do not remove the divider in the top
freezer basket.
2. While supporting door front,
hook supports into tabs
WARNING
located on inside of rail.
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before removing doors. After replacing
doors, connect power.
3. Lower door front into
final position.
CAUTION
To avoid possible injury, product, or property
damage, you will need two people to perform the
following instructions.
To Remove:
4. Replace and tighten Phillips screws that were
1. Pull drawer open to full extension.removed from each side of rail system (select
models).
2. Pull upper basket out to full extension and lift out
to remove.5. Place the basket cradles back onto the side rails.
Align snaps with the slots on the side rails and
3. Lift lower basket straight up and out to remove.
press each snap towards the rail until it clicks.
4. On each side rail is a
6. With rails pulled out to full extension, set the
basket cradle with two snap
basket straight down into the basket cradles.
attachments. To release
each cradle, unlatch the
Basket cradle
snaps by pushing them
snap attachments
inward, away from the side
rail system. Lift the cradles
off of the rails.
5. Remove Phillips screw
from each side of rail
select models
7. Slide upper basket into freezer. Make sure that rear
of basket hooks behind rail catch.
6. Lift top of drawer front
to unhook supports
from rail system. Lift
door front out to
remove.
5 |
ACEC
