Figure 22 Fiaure 24
WALL
----!I r RAIL
INSTALLED ON
BOTH SIDES
14 . Insert end tabs on wall rail through slot in
each support assembly (see Figure 25). Slide
each support assembly toward house. Be sure
wall rail is positioned firmly against exterior
wall. NOTE: If your house is constructed of a
material that could be damaged by the wall
mounting support, fasten a board between
12 l Construct outside support assemblies by
wall rail and side of house.
fastening vertical and angle supports together
with 3/4? bolts, washers and nuts. Tighten
securely (see Figure 23). Figure 25
Figure 23 l/b
ENil TAB 0
LOCK
PLAIN
FASTEN BOLT
15 . Tighten nuts securely. Tighten the nuts closest
SECURELY to the wall last to assure that the wall rails
fit snugly against your house.
16 . Install window rail seal and window lock
bracket and drain cup. Press foam meeting
rail seal into place and cut to proper length
(see Figure 26.) Mark and make a l/8? pilot
13 . Position support assemblies against bottom hole, then install lock bracket using wood
rail of cabinet and slide toward house, allowing
screw.
approximately one-inch clearance between
end of angle support and wall (see Figure 24).
Select proper sets of square holes in cabinet
rails and fasten support assemblies to cabinet
rails by using 3/4? bolts, washers and nuts.
Do not tighten nuts. Leave assembly loose, so
you can make adjustments to support
assemblies later. Seal small openings around installation with
gum-type sealer.
11 |
ACEC
