To set the Timer to turn on the air conditioner, changing 9. After 5 seconds, Timer indicator light will remain on. Display
the previous settings:will show the current room temperature.
1. Turn on air conditioner.
To clear Timer delay program:
2. Adjust the mode to Cool, Dry, Fan or Heat (Heat/Cool models
NOTE: Air conditioner can be either on or off.
only).
3. For Cool or Heat (Heat/Cool models only) mode: 1. Press TIMER once after it has been programmed. Display will
show remaining time.
 Adjust fan speed to High, Med, Low or Auto.
2. While the display is showing the remaining time, press TIMER
 Adjust temperature between 64oF and 90oF (18oC and
again. Timer indicator light will turn off.
32oC).
4. For Fan mode, adjust fan speed to High, Med or Low.To see or change the remaining time (in hours):
NOTE: In Fan mode, temperature cannot be set.1. Press TIMER once after it has been programmed. Display will
show remaining time.
5. For Dry mode, adjust temperature up or down by 4oF (2oC).
2. While the display is showing the remaining time, press the
6. Turn off air conditioner.
plus or minus TEMP button to increase or decrease the time.
7. Press TIMER. Timer indicator light will flash. Display will show
3. After 5 seconds, the display will show the current room
remaining hours before the air conditioner will turn on.
temperature.
8. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours.
Using the Remote Control
NOTE: Remote control may differ in appearance.
Power
Press POWER to turn on air conditioner.
Mode
Press MODE to select Cool, Dry, Fan or Heat (Heat/Cool models
only).
th?
6 SenseSystem Control
The air conditioner automatically selects Cool or Dry mode,
depending on room temperature and sets the temperature to
79oF (26oC).
NOTE: One CR2025 battery (included) powers the remote  The temperature set point can be adjusted down to 75oF
control. Replace battery after 6 months of use, or when the (24oC) or up to 83oF (28oC). Press the up or down arrow
remote control starts to lose power. button once to change the temperature 2oF (1oC) or twice to
change it 4oF (2oC).
 If the current room temperature is lower than the temperature
set point, Dry mode is selected. Fan runs on Auto speed only.
 If the current room temperature is higher than the
temperature set point, Cool mode is selected. Fan speed may
be selected by the user.
th?
1. Press 6 Sense System control.
2. In Cool mode, press FAN to select High, Med, Low or Auto.
15 |
ACEC
