A separate electrical supply is required on a
RECEPTACLE WIRING
separately fused circuit. Do not fuse ground-
neutral.
RECEPTACLE WIRING should be at least as
large as size shown on electrical Chart B. Use
See Chart C for receptacle voltage require-
copper wire only. It is the personal responsibility
and obligation of the customer to provide proper ments, proper fuse size, wire and wiring con-
and adequate receptacle wiring installed by a nections which must conform with rating of
the appliance. Do not use an extension cord.
qualified electrician. OBSERVE NATIONAL
ELECTRICAL CODE AND ALL LOCAL
GOVERNING CODES AND ORDINANCES.
RECOMMENDED GROUNDING METHOD
Chart-C
For your personal safety, this appliance must be
grounded. This appliance is equipped with a RECEPTACLE
PLUG AND VOLTAGE
power supply cord having a 3-prong grounding RECEPTACLE (60 HERTZ SERIAL PLATE
plug. To minimize possible shock hazard, the DATA AC IN ALL AMPERES
cord must be plugged into a mating 3-prong
grounding type wall receptacle, grounded in
accordance with the National Electrical Code
and local codes and ordinances. If a mating wall
receptacle is not available, it is the personal
responsibility and obligation of the customer to
have a properly grounded 3-prong wall receptacle
installed by a qualified electrician.
USE TIME-DELAY
FUSE
OR TIME MINIMUM TYPE
ELECTRICAL DELAY CIRCUIT RECEPTACLE OF BRANCH
BREAKER WIRE SIZE CIRCUIT
RATING IN
REQUIREMENTS AMPS
For 230 volt and 230/208 volt models with serial
plate amperes up through 16.0
Refer to Chart C for specific wiring and recep-
tacle information to be used.
RECEPTACLE WIRING
OBSERVE ALL LOCAL GOVERNING CODES
AND ORDINANCES.
RECEPTACLE WIRING should be at least as
Do not, under any circumstances, remove the large as size shown on electrical Chart C. Use
power supply cord ground plug. copper wire only. It is the personal responsibility
and obligation of the customer to provide proper
and adequate receptacle wiring installed by a
ELECTRICAL GROUND IS REQUIRED ON
qualified electrician. OBSERVE NATIONAL
THIS APPLIANCE.
ELECTRICAL CODE AND ALL LOCAL
GOVERNING CODES AND ORDINANCES.
A three-wire, single-phase 60 hertz AC only
electrical supply is required. |
ACEC
