Mode Filter Monitor
1. Press MODE until you see the indicator light glow for the 1. When Filter Monitor indicator light is lit, remove, clean and
desired setting. replace the air filter. See ?Cleaning the Air Filter.?
2. Choose Cool, Dry or Fan.2. Press FILTER MONITOR after cleaning and replacing the air
 Cool?Cools the room. Press FAN SPEED to select High, filter. This resets the filter monitor.
Med, Low or Auto. Press the plus or minus TEMP button
to adjust the temperature.
 Dry?Dries the room. The air conditioner automatically
selects the temperature. Fan runs on Low speed only.
NOTE: Dry mode should not be used to cool the room.
 Fan?Only the fan runs. Press FAN SPEED to select High,
Med or Low. The display shows the current room
temperature.
NOTE: Auto fan speed cannot be selected in Fan mode.NOTE: After 360 hours of fan operating time, the filter indicator
light will turn on. It will remain on for 180 hours or until you press
FILTER MONITOR. After 180 hours, it will turn off automatically.
Temperature
 Press the plus TEMP button to raise the temperature. Each
NOTE: After 5 seconds, display will show the current room time you press or hold the plus TEMP button, the
temperature.temperature will go up 2oF (1oC) until it reaches 90°F (32°C).
NOTE: After 5 seconds, the display will show the current
Fan Speed
room temperature.
NOTE: The Fan Speed button will operate only when the Cool or
Fan mode has been selected.
1. Press FAN SPEED until you see the indicator light glow for
the desired setting.
2. Choose High, Med, Low or Auto.
 High?for maximum cooling
 Med?for normal cooling
 Low?for sleeping comfort
 Auto?automatically controls the fan speed depending on  Press the minus TEMP button to lower the temperature. Each
the current room temperature and temperature control time you press or hold the minus TEMP button, the
settingtemperature will go down 2oF (1oC) until it reaches 64°F
NOTE: Auto fan speed cannot be selected in Fan mode.(18°C).
NOTE: After 5 seconds, the display will show the current
room temperature.
Timer Delay
To set the Timer for a 30-minute to 24-hour delay until the
air conditioner turns off (the air conditioner must be On):
1. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn off.
NOTE: After 5 seconds, the display will show the current room
temperature.
2. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours.
3. After 5 seconds, Timer indicator light will remain on. Display
will show the current room temperature.
10 |
ACEC
