Complete Installation
1. Insert foam seal behind the top of the lower window sash and
against the glass of the upper window.
WARNING
A
B
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
A.Top of lower window sashDo not use an adapter.
B.Foam seal
Do not use an extension cord.
2. Use a 1??" drill bit to drill a starter hole through the hole in the Failure to follow these instructions can result in death,
top channel.
fire, or electrical shock.
3. Attach the top channel to the window sash with one 3??" screw
to secure the window in place.
4. Plug into a grounded 3 prong outlet.
5. Press RESET on the power supply cord. See ?Electrical
Requirements.?
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the  Do not try to operate your air conditioner in the Cool mode
best possible results. when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
This section explains proper air conditioner operation.
operate properly.
IMPORTANT:
NOTE: In the event of a power failure, your air conditioner will
 If you turn off the air conditioner, wait at least 3 minutes
operate at the previous settings when the power is restored.
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Starting Your Air Conditioner?Digital Control
1. Remove the clear protective film from the front panel badge.
2. Press POWER to turn on the air conditioner.
NOTE: When the air conditioner is turned on for the first time
after it is plugged in, the display will show the current room
th?
temperature and will run in the 6 Sense System control.
When the air conditioner is turned on at all other times, the
display will show the previous settings for 5 seconds, and
then show the current room temperature.
3. Select mode. See ?Mode.?
NOTE: When the air conditioner is set to Fan mode and the room
temperature is below 32oF (0oC), the display will show LO. If the 4. Select fan speed. See ?Fan Speed.?
room temperature is above 99oF (37oC), the display will show HI.
5. Set temperature. See ?Temperature.?
9 |