AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the Do not try to operate your air conditioner in the cooling mode
best possible results. when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
This section explains proper air conditioner operation.
operate properly.
IMPORTANT:
If you turn the air conditioner off, wait at least 3 minutes NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Starting Your Air Conditioner?Digital Control
Mode
1. Press MODE until you see the indicator light come on for the
setting you desire.
2. Choose Cool, Fan Only or Power Saver.
Cool?Cools room. You can adjust temperature by
pressing the plus or minus button. You can select fan
speed by pressing Fan Speed.
Fan Only?Only the fan runs. You can select the fan
speed by pressing Fan Speed, but you cannot adjust the
Temperature control setting. Display shows the current
room temperature.
Power Saver?Fan runs only when cooling is needed. You
can select the fan speed by pressing Fan Speed.
Because the fan does not circulate the room air
continuously, less energy is used, but the room air is not
circulated as often. Use Power Saver when you are
NOTES:asleep or away from home.
When the air conditioner is off, the display shows the current
room temperature.
If the room temperature is below 55oF (13oC), the display will
show 55oF (13oC). If the room temperature is above 99oF
(37oC), the display will show 99oF (37oC).
Fan Speed
1. Remove clear protective film from control panel and front
panel badge (on some models).1. Press FAN SPEED until you see the indicator light come on
2. Press POWER to turn on air conditioner.for the setting you desire.
2. Choose Turbo, High, Low or Auto.
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool
mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is
turned on at all other times, it will display the previous Filter Monitor
settings for 3 seconds, and then display the room
temperature. 1. When filter indicator light is lit or flashing, remove, clean and
replace air filter. See ?Cleaning the Air Filter.?
3. Select mode. See ?Mode.?
2. Press and hold FILTER for 3 seconds after cleaning and
4. Select fan speed. See ?Fan Speed.?replacing the air filter. This resets the filter monitor.
5. Set temperature. See ?Temperature.?
NOTE: After 360 hours of fan operating time, the filter indicator
light will turn on. It will remain on for 180 hours or until you press
FILTER. After 180 hours, it will flash. It will continue flashing until
you press FILTER.
11 |
ACEC
