Operating Your Air Conditioner
EN
Operating your air conditioner properly helps you to obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
Y If you turn the air conditioner off, wait at least 3 minutes before turning it back on. This prevents the air conditioner from
blowing a fuse or tripping a circuit breaker.
Y Do not try to operate your air conditioner in the cooling mode when outside temperature is below 65!F (18!C). The
inside evaporator coil will freeze up and the air conditioner will not operate properly.
Starting your air conditioner
1.Set the EXHAUST Control (some models) to
CLOSEDOPEN
CLOSED for maximum continuous cooling. The
EXHAUST Control allows you to draw stale or
smoky air from the room.EXHAUST
OPEN - to exhaust room air to the outside.
CLOSED - to circulate room air.
The EXHAUST Control will function only when FAN
CONTROL is operating.
2.Set the FAN CONTROL to the desired setting.Your air conditioner has one of these controls:
When the air conditioner is operating at LOWOFF
COOL, HIGH COOL (some models), or TURBO
COOL, the fan circulates air continuously.
FANTURBOFAN CONTROL
ONLYCOOL
TURBO COOL - for maximum cooling
HIGH COOL (some models) - for normal
coolingLOWCOOL
LOW COOL - for sleeping comfort
OFF
FANTURBO
FAN ONLYONLY COOL
When the FAN ONLY setting is selected, the fan will
run continuously to move air, but the air will not beFAN CONTROL
cooled.
LOWHIGH
COOLCOOL
POWER SAVER (some models)
When the air conditioner is operating on POWER
SAVER, the fan runs only when cooling is needed.FAN
ONLY
The fan stops circulating air when the roomOFFPOWER
SAVER
temperature matches the THERMOSTAT Control
setting.LOWFAN CONTROL
COOL
Since the fan does not circulate the room air
HIGH
continuously, less energy is used but the room air isCOOL
TURBO
not circulated as often. Use POWER SAVER whenCOOL
you are away from home or asleep.
HEAT/COOL AIR CONDITIONER HEATOFFTURBOTURBO
HEATCOOL
SETTINGS
TURBO HEAT - for maximum heatingHIGHHIGH
HEATCOOLFAN CONTROL
HIGH HEAT - for normal heating
LOW HEAT - for reducing heatingLOWLOWCOOL
HEAT
FAN ONLY (some models) -for circulating airFANONLY
without heating or cooling
5 |