ENPerforming Annual Maintenance
3.Remove green ground
wire (A) from cabinet
WARNING
base. Keep ground screw
to reattach ground wire
after cleaning.
NOTE: Do not lift, push, or
pull on any expanded
polystyrene (foam) from
inside the air conditioner.A
Electrical Shock Hazard
4.Pull on handle to remove
Disconnect power before doing any maintenanceair conditioner from cabinet..
Do not drink water collected by the airTake care when handling areas
with sharp metal fins.
conditioner.
5.Wrap fan motor (B),
Failure to follow these instructions can result inG
connector plug (C),
death, electrical shock, or sickness.
electrical control bo(D), x B
and compressor terminalsC
(E)in plastic film and
make sure no water or
WARNING
other liquid gets inside
any of these parts. It
Excessive Weight Hazardcould damage theF
Use two or more people to move and install insulation and causeH
E
air conditioner.serious mechanical
DI
problems.Failure to do so can result in back or other injury.
6.Carefully clean and hose
out base (F), condenser coil (G), evaporator coil (H),
Your air conditioner needs annual maintenance to help
and condensate pan (I). Clean at least once a year or
ensure steady, top performance throughout the ymore often if the condenser and eear.vaporator coils and
Call your local authorized dealer to schedule an annpan collect dirualt, sand, leaves, insects, or algae.
checkup. The expense of an annual inspection is yAlsoour, clean if you detect an odor coming from
responsibilityOR .the air conditioner.
If you are familiar with electrical appliances7., yRemoou can dove plastic film from motor and electrical parts.
the cleaning and maintenance yourself. If you choose to
do so, follow these steps:
1.Unplug air conditioner or disconnect power.
WARNING
2.Remove front panel (See OCleaning the front panel�
on page 10).
Electrical Shock Hazard
Connect green ground wire to ground screw.
Failure to do so can result in death or electrical
shock.
8.Replace air conditioner into cabinet. Reattach ground
wire to cabinet base with ground screw. Replace front
panel.
NOTE: Route power supply cord through notch in front
panel. Make sure power supply cord does not interfere
with front panel screw.
NOTE: Wait 24 hours before starting the air conditioner
again. This allows time for all areas to dry out.
9.Plug in air conditioner or reconnect power.
12 |
ACEC
