TROUBLESHOOTING GUIDE
If a fault occurs, before contacting our After-Sales Service, make the following
checks to try and remedy the problem.
Restart the wash programme to see if the
Other fault signals End depending
fault repeats.
on the model installed:
Press theStar buttont for about 5 seconds
until the Start indicator lamp switches offThe programme. progress indicator lamp on
the control panel flashes:
Briefly press the Star buttont.
If the malfunction persists, switch off the Detach the lower spray arm. Check crockery and
cutlery have been loaded correctly and that the
appliance and turn off the water tap. Call our
lower spray arm has been correctly fitted.
After-Sales Service.
The appliance will not switch on.Crockery still dirty after washing:
Power plug properly inserted in the mains Have you selected the correct programme?
socket? Have you used the correct amount of
Power failure?detergent?
Have you switched the dishwasher on? Filters clogged or incorrectly assembled?
Have you pressed the Star bt utton? Spray arms blocked or nozzles clogged?
Have you set the delay timer (if fitted)?Salt container cap screwed down?
Tap turned on? If not: Crockery loaded correctly? (the water jets
Turn on the water tap.must spray the entire surface of all items).
Make sure the water hose filter is notSpott ed crockery:
clogged.
Water hardness duly checked and
To do this, turn off the water tap, disconnect
regulated?
the water hose, clean the filter, reconnect
Salt container empty?
the water hose to the tap and turn on the tap.
Insufficient detergent?
Filters clogged?
Crockery loaded upside down? Spotted glasses and cutlery:
When loading large items in particular, mak Too much rinse e aid? (Adjust the rinse aid
sure the water circulates and does not regucollectlator to a lower setting).
inside them.Note:
Door closed properly?On some models when the Star but tton is
Fault indicated?pressed, a pre-rinse cycle is performed prior to
The Star indicattor lamp flashes:the actual wash programme to regenerate the
water softener system.
AFTER-SALES SERVICE
Before contacting our After-Sales Service,If, after carrying out the
above checks the
1. Try to remedy the problem
malfunction persists,
(See ?Troubleshooting guide?).
call our After-Sales
2. Switch off the dishwasher and restart the
Service and specify:
wash programme to see if the fault repeats.
the nature of the
problem;
the appliance type
and model;
the service number
(the number after the word Service on the
adhesive label) located inside the door on the
right hand side;
your name, address and telephone number.
75 |
ACEC
