Maintenance
To replace:
Oven Door
1. Fit the ends of the drawer glides into the rails in the range.
CAUTION2. Lift up the front of the drawer and gently push in to the
first stop position.
Do not place excessive weight on or stand on an open
oven door. This could cause the range to tip over, break3. Lift drawer up again and push until drawer is closed.
the door, or injure the user.
Important: The oven door on a new range may feel spongyLeveling Legs
when it is closed. This is normal and will decrease with use.
CAUTION
Oven WindowBe sure the anti-tip bracket secures one of the
rear leveling legs to the floor. This bracket
To protect the oven door window:prevents the range from accidentally tipping.
1. Do not use abrasive cleaning agents such as steel wool
The range should be leveled when installed. If
scouring pads or powdered cleansers as they may scratch
the range is not level, turn the leveling
the glass.
legs, located at each corner of the
ANTI-TIP BRACKET
2. Do not hit the glass with pots, pans, furniture, toys, or otherANTI-TIPrange, until range is level.
BRACKET
objects.
LEVELING LEGLEVELING LEG
3. Do not close the oven door until the oven racks are in
Oven Light
place.
Scratching, hitting, jarring or stressing the glass may weaken
CAUTION
its structure causing an increased risk of breakage at a later
date.Y Disconnect power to range before replacing light bulb.
Y Allow oven to cool before replacing light bulb.
Storage Drawer
Y Make sure bulb cover and bulb are cool before touching.
CAUTION
To replace oven light bulb:
Do not store plastic, paper products, food or flammable1. When oven is cool, hold bulbBULB COVER
materials in this drawer. The drawer may become too warmcover in place, then slide wire
for these items when the oven is in use.retainer off cover.
Important: Bulb cover will
The storage drawer can be removed to allow you to clean
fall if not held in place
under the range.
while removing wire
WIRE
To remove:retainer.RETAINER
1. Empty drawer and pull out to the first stop position.2. Remove bulb cover and light bulb.
2. Lift up the front of the drawer.3. Replace with a 40-watt appliance bulb.
3. Pull out to the second stop position.4. Replace bulb cover and secure with wire retainer.
4. Grasp sides and lift drawer up and out.5. Reconnect power to range. Reset clock.
7 |
ACEC
