Instead it shall be handed
tes that this appliance may e doors and shelves so that
iance unusable by cutting off orized dump; do not leave it covery and recycling of this
, which could otherwise be handling of this product. nufactured, and retailed in
al and Electronic Equipment waste disposal. Deliver the ocal city office, your household shop where you purchased the n CFCs (replaced with R134a) connected to an approved
tive consequences for the ildren. For more detailed th low environmental impact. to store food and is
b inside the appliance. the appliance can only be e rear of the appliance)r and area code.
tronic equipment.
73/23/EEC;89/336/EEC amended by Directive 93/68/EEC.
This appliance is designedmanufactured in conformity with European Directive 90/128/EEC, 02/72/EEC and Regulation (EC) No. 1935/2004Thisappliance is designed, macompliance with: -the safety objectives of the Low Voltage Directive -the protection requirements of the "EMC" Directive The electrical safety of guaranteed if the product isearth connection.the nature of the fault,the model,the service number (the number after the word SERVICE on the rating plate on thyour full address,your telephone numbe
2.Scrapping The appliance is manufactured using recyclable material. This appliance is marked according to the European directive 2002/96/EC on Waste Electric(WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negaenvironment and human healthcaused by inappropriate waste The symbol on the product, or on the documents accompanying the product, indicanot be treated as household waste.over to the applicable collection point for the recycling of electrical and elecBefore scrapping, make the applthe power cable and removing thchildren cannot easily climDisposal must be carried out in accordance with local environmental regulations for appliance immediately to an authunattended even for a few days, since it is potentiallydangerous for chinformation about treatment, reproduct, please contact your lwaste disposal service or the product. Information: This appliance does not contaior HFCs (replaced with R600a). Appliances with Isobutane (R600a): Isobutane is a natural gas wiCaution is required, however, since isobutane is flammable. Therefore, it is essential to ensure that refrigerant pipelines are not damaged. Declaration of conformitySpecify:
rrectly positioned?
is off and the appliance is is off and the appliance is the external walls of the this course of action, contact
ry warm room or near heat rnal walls of the appliance
(depending on model) been ged or deformed? (See chapter they are potentially dangerous.disconnect the appliance from
r drainage plugs co
After-Sales Service:
See if you can solve the problem yourself.Switch the appliance on again to see if the problem has been solved. If it has not, the power supply and wait for about an hour before switching on again.If the problem persists after After-Sales Service.
not working.Is there a power failure?Is the plug properly inserted in the socket?Is the electric cable intact?working.The green LED is not working. Contact the After Sales Service for a replacement.Have hot foods been put in the appliance?Has the appliance lid been left open for a long time?Is the appliance placed in a vesources?Is the thermostat setting correct?Has the fast freeze function pressed by mistake?Are the defrost wateIs the appliance lid properly closed?Is the appliance lid seal dama?Installation?)Have the 4 protection pieces been removed? (See chapter ?Installation?)appliance.It is normal for condensation to form under certain atmospheric conditions (humidity above 85%) or if the appliance is located in a damp or poorly ventilated room. The performance of the appliance is in no way affected.is not uniform.This phenomenon is quite normal.
AFTER-SALES SERVICEBefore contacting 1.2.3.
3.The green LED (if provided) 4.The green LED (if provided) 5.The compressor runs continuously.6.Too much ice on the upper edge.7.Formation of condensate on8.The layer of ice on the inteSAFEGUARDING THE ENVIRONMENT1.Packing The packaging material is entirely recyclable, and marked with the recycling symbol. Follow local regulations for scrapping. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as
or heat up the interior frigerating circuit after the
d from under the appliance?
t damage to the appliance nce, unplug the appliance.e at least once a year.
th other furniture or objects
from your appliance, carry
cooling grille (depending on model).
INSTRUCTIONS FOR USEe perfectly normal.
r defrosting, using a sponge dampened
setting correct?
appliance from
Gurgling noises from the re
Place a bowl beneath the drainage channel to collect the residual water. If available, use the divider.Speed up defrosting by using a spatula to detach the ice from the appliance walls.Remove the ice from the bottom of the appliance.In order to avoid permaneninterior, do not use pointed or sharp metal instruments for removing the ice.Do not use abrasive productsartificially.Dry the interior of the appliance thoroughly.On completion of the defrosting, refit the plug.Remove the ice from the upper edge (see the Troubleshooting Guide).Clean the inside aftewith warm water and/or mild detergent.Clean the side motor Remove dust from the condenser on the rear of the appliance.Disconnect the the mains power supply.Remove the diffuser by following the sequence of steps shown in the figure.Unscrew the light bulb and replace it with an identical bulb of the same wattage and voltage.Refit the diffuser and plug in the appliance.Is there a power failure?Is a defrosting operation in progress?Is the appliance lid properly closed?Is the appliance placed near a heat source?Is the thermostatAre the ventilation grille and condenser clean?Is the appliance perfectly horizontal?Is the appliance in contact withat may cause vibrations?Has the packaging been remove
CARE AND MAINTENANCEBefore carrying out maintenaDo not use abrasive products, scourers or stain-removers (e.g. acetone, trichloroethylene) to clean the appliance. To obtain the best results out cleaning and maintenancCHANGING THE LID LIGHT BULB (IFPROVIDED)TROUBLESHOOTING GUIDE1.The red LED (if provided) remains alight.2.The appliance is too noisy.Note: compressor cuts out ar
children or
that the appliance is not th liquids in the appliance and in an area suitable for its the climatic class indicated nufacturer to speed up the
to play or hide inside the
places exposed to direct in order to avoid increasing for use by youngreplaced by an authorized be possible either by the appliance and wrap them
nce they may cause cold burns.the appliance, unplug it from being trapped and therefore cated on the appliance data ted when the thickness of ice om the mains power supply.water drain plug (depending
e electrical power supply.
y and well-ventilated place. ically recommended by the
appliances inside the product, unless
damage the floors when you move the rnal defrost
After installation, make sure standing on the power supply cable.Do not store glass containers wisince they may burst.Do not eat ice cubes or ice lollies immediately after taking them out of the appliance siBefore servicing or cleaning the mains or disconnect thDo not install the appliance insunlight or near heat sources power consumption.Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.Install the appliance in a perfectly horizontal position, on a floor strong enough to take its weight size and use.Install the appliance in a drThe appliance is set for operation at specific ambient temperature ranges, according toon the data plate located at the rear of the product. The appliance may not work properly if it is left for a long period at a temperature above or below the indicated range.If the appliance is left empty for short periods, it is preferable not to switch it off.Be careful not to appliance (e.g. parquet flooring).Do not use mechanical devices or any means other than those recommended by the madefrosting process.Do not use electricalsuch appliances are specifmanufacturer.This appliance is not designed the infirm without supervision.To avoid the risk of childrensuffocating, do not allow them appliance.The power cable may only be person.Do not use extension leads or adapters.Electrical disconnection mustunplugging the appliance or by means of a double-pole switch located upline from the socket.Ensure that the voltage indiplate corresponds to the domestic supply voltage.Do not ingest the contents (non-toxic) of the ice packs (ifprovided).Restrict the number of times you open the lid.Disconnect the appliance frRemove the packs of food fromclose together in newspaper and store in a very cool place or thermally insulated bag.Leave the appliance lid open.Remove the internal defrost on model).Remove the extewater drain plug (depending on model) and reposition it as shown in the figure.
GB
PRECAUTIONS AND GENERAL RECOMMENDATIONSDEFROSTING THE APPLIANCEThe appliance should be defroson the walls reaches 5-6 mm. |
ACEC
