Installation
Door ReinstallationPullout Freezer Drawer
1. Install hinge assemblies:
WARNING
Y Install center hinge with
To avoid electrical shock which can cause severe
Phillips screws.
personal injury or death, disconnect power to
2. Place hinge side of refrigeratorrefrigerator beforeremoving doors. After replacing
door on center hinge pin.
doors, connect power.
5
Y Install top hinge with �16�hex head screws.
CAUTION
3. While holding refrigerator door upright, tighten
5
down top hinge with �16� hex head driver.To avoid possible injury, product, or property
4. Reconnect connector.damage, you will need two people to perform the
following instructions. Important: Alwaysunload
5. Connect the waterline
food in freezer trays beforeremoving trays.
tubes firmly by pushing oneConnector
waterline inside the other.
To Remove:
6. Slide the black locking
1. Pull drawer open to full
collar fully forward.
Tabsextension.
7. Hold tabbed section of
waterline. 2. Slide freezer drawer forward
and lift straight out.
8. Rotate black locking collar
counterclockwiselocking
water lines in place. A
Oclick� is heard ensuring3. Remove Phillips screws from
waterlines are correctlyeach of the drawer slides.
locked in place. The Oarrow�
on the tabbed section should
align with the 2 bars on the
black locking collar.
9. Ensure the connection does
not leak beforeinstalling the
upper hinge cover.
4. Lift top of drawer front to
10. Replace top hinge covers.unhook the drawer from the
slides.
5. Move drawer slides fully
forward.
6. Lift out lower drawer assembly.
6 |
ACEC
