NC
INSTALLATION
xInstallationmustcomplywithcurrentlocal
Technical information for installer
This cooking hob can be embedded in aregulations.
worktop 20 to 50 mm thick.xIntheroomwherethecookinghobisinstalled,
there must be enough air to allow the gas to
If there is no oven beneath the cooktop �anyburn correctly �see relevant tableO.
oven installed must be manufactured by usxThenaturalflowofairmusttakeplacethrough
and equipped with a cooling systemO, insert aan adequate opening, that must be:
separator panel at a minimum distance of 20î permanent, made on one of the outside walls
mm from the bottom of the cooktop.of the room, and communicating with the exterior
Note: before installation, make sure that the
local gas delivery conditions �nature andin an area away from sources of pollution;
pressure of gasO are compatible with theî built so as to ensure that its openings, both on
the inside and on the outside, cannot be
settings of the cooking hob, as indicated onobstructed, intentionally or accidentally;
the rating plate.î protected by a metal grid or mesh that does
xIfaverticalpieceoffurnitureisinstalled,not reduce its working section;
there must be a gap of at least 100 mmî situated near the floor level and positioned so
between it and the edge of the cookingas not to interfere with the operation of the fume
hob.exhaust devices.
xBeforeinstallingthecookinghob,removethe
plastic film that protects it, if present.
The outer surfaces of the furniture or appliances
adjoining the cooking hob must be heat resistant
�heat protection oYó, according to standards
EN 60335î2î6O.
Assembly
xApplythesuppliedgaskettothecooking
hob �unless it has already been fittedO, after
having cleaned its surface as shown in the
relevant figure.
To fasten the cooking hob, use bracketsa
supplied with it.
1. Fit the brackets into the relevant bores and fasten
them by means of their screws.
2. Make an opening in the worktop, respecting the
dimensions indicated in the enclosed product
description sheet.
3. Install the cooking hob in the worktop.
Important: the power supply cable and plug
must be suitable for the power absorption of
the cooking hob, and the cable must be long
enough to permit the upward extraction of the
cooking hob.
15
MY15 GB 67872/C |
ACEC
