NC
INSTALLATION
Adjustment to different types of
gasa
If a different type of gas from the one indicated
in the plate is used, the cooking hob must beb
adapted to it.
1. The gas nozzles must be changed by
AfterîSales Service or a qualified technician.
Nozzles not supplied with the appliance must
be ordered from AfterîSales Service.
c
2. Connect the cooking hob to the gas shutîoff
valvebymeans of apipesuitablefor the
type of gas used, in compliance with current
local regulations.
3. Adjust the minimum setting of the taps.
Note: when liquid petroleum gas is used �G 30/
G 31O, the minimum gas setting screws must be
tightened as far as they will go.
Replacing the injectors �see table in
enclosed product description sheetOd
1. Remove gridsa .
2. Extract burnersb .e
3. Using a socket spanner of the appropriate
size,c, unscrew the injector to be replaced.î
4. Replace it with the injector suitable for the
new type of gas.
5. Reîassemble the injector ind .
6. For models equipped with a triple crown
burner, proceed as shown in figure.
xRemovethetwoscrewsffollowedby
the capg then replace both injectorsd
as previously described.
Replace the capg, ensuring the seal is
properly positioned before attempting to
use the cooktop.
7. Before installing the cooktop, remember to
affix the gas calibration plate supplied with
the injectors in such a way that it covers the
existing information relating to gas calibration.
Adjusting minimum gas setting
of taps
To ensure that the minimum setting is correctly
adjusted, remove knobe and proceed as
follows:
xtighten�îOtoreducetheheightoftheflame;
xloosen�+Otoincreasetheheightofthe
flame.
The adjustment must be performed with the tap
in minimum gas setting position �small flameO .
17
MY
17 GB 67873 |