NC
INSTALLATION
xInstallationmustcomplywithcurrentlocal
Technical information for the installer
This cooking hob can be embedded in aregulations.
xIntheroomwherethecookinghobisinstalled,
worktop 20 to 50 mm thick. If anotherthere must be enough air to allow the gas to
appliance is not fitted under the cooking hob,
insert a separator panel, at a distance of atburn correctly �see relevant tableO.
least 20 mm from the cooking hob bottom.xThenaturalflowofairmusttakeplacethrough
an adequate opening, that must be:
Note: before installation, make sure that theî permanent, made on one of the outside walls
local gas delivery conditions �type and pressure
of gasO are compatible with the settings of theof the room, and communicating with the exterior
in an area away from sources of pollution;
cooking hob, as indicated on the rating plate.î built so as to ensure that its openings, both on
xIfaverticalpieceoffurnitureisinstalled,the inside and on the outside, cannot be
there must be a gap of at least 100 mmobstructed, intentionally or accidentally;
between it and the edge of the cookingî protected by a metal grid or mesh that does
hob.not reduce its working section;
xBeforeinstallingthecookinghob,removetheî situated near the floor level and positioned so
plastic film that protects it, if present.as not to interfere with the operation of the fume
The outer surfaces of the furniture or appliancesexhaust devices.
adjoining the cooking hob must be heat resistant
�heat protection oYó,accordingtolocal
standardsO.
Assembly
xApplythesuppliedgaskettothecooking
hob �unless it has already been fittedO, after
having cleaned its surface, as shown in
figure.
To fix the cooking hob, use bracketsa supplied
with it.
1. Position the brackets on the relevant bores and
fix them by means of their screws.
2. Make an opening in the worktop, respecting the
dimensions indicated in the enclosed product
description sheet.
3. Install the cooking hob in the worktop.
Important: the power supply cable and plug
must be suitable for the power absorption of
the cooking hob, and the cable must be long
enough to permit the upward extraction of the
cooking hob.
56
MY
56 GB 68461 |
ACEC
