ELECTRICAL CONNECTION
Make sure the appliances are installed The appliance must be connected to the
and connected to the electricity supply electricity supply by means of an all-pole
by a qualified technician in accordance disconnect switch with minimum contact
with the manufacturer?s instructions and gap of 3 mm.
in compliance with local regulations. The appliances must be earthed by law.
The installer is responsible for the correct
electrical connection of the appliances Do not use multiple plug adapters or
extension leads.
and the observance of the relative safety
prescriptions. After the appliances have been installed,
the electrical components must be
inaccessible.
Connecting the oven to the power supply
Make sure that the voltage shown on the rating
plate is the same as the power supply voltage in
your home. The rating plate is on the front edge of
the oven cavity (visible with oven door open).
Use a type H05RR-F power cord
(minimum length 800 mm).
Warning: All the oven's components operate at
230-240V. When using a 400 V connection,
make sure that the voltage reaching the oven is
230-240V, as illustrated in the side table.
Conductors X numberConnection
H05 RR-F 3X4 mm2
1N+ ~
H05 RR-F 4X2,5 mm2
2N+ ~
H05 RR-F 4X2,5 mm2
3+ ~
H05 RR-F 5X1,5 mm2
3N+ ~
Interconnecting cooktop and oven
Before connecting the oven to the power supply,
check that the cooktop is among the ones listed in
the cooktop/oven pairing product sheet.Connect
the 3 pole and 4 pole connectors to the respective
connectors on the oven.
The 3 pole connectorsH) is lo (cated at the rear
right hand side of the control panel, the 4 pole
connector (J) is located at the top of the oven in the
left hand corner (see figure).
Connect the yellow/green striped earth wire ()
(K) from the cooktop to the screw located near the
3 pole connector.
WARNING: DO NOT CONNECT TO THE
POWER SUPPLY BEFORE YOU HAVE
FINISHED CONNECTING THE OVEN AND
COOKTOP.
Mount the oven in the kitchen unit.
Make sure the power cord is not entrapped.
18 |
ACEC
