Temperature Controls
The fresh food control is located at the top of the fresh
TEMPERATURE CONTROL GUIDE
food compartment.
Fresh FoodAdjust fresh food control
Compartmentto next higher setting.
too Warm
Fresh FoodAdjust fresh food control
Compartmentto next lower setting.
The freezer control is located at the back of the freezertoo Cold
compartment.
Freezer too WarmAdjust freezer control to
INITIAL SETTINGnext colder setting.
Freezer too ColdAdjust freezer control to
COLDESTCOLDnext warmer setting.
Turn Refrigerator Set fresh food control to
OOFF�OOFF�.*
FREEZER CONTROL
YTurning the fresh food control to OOFF� stops cooling
in both compartments. It does not shut off power to
Initial Settingsthe refrigerator.
YThe fresh food control has settings from 1 (cold) to
7 (coldest). Initially set this control on 4.
No Defrosting
YThe freezer control has settings from cold to coldest.Your refrigerator is designed to defrost automatically.
Initially set this control at the mid-line initial setting.
Note
Note
Y During the automatic defrost cycle, you may notice
YYour refrigerator will run continuously for severala red glow/reflection in the vents on the back wall
hours when you first start it. This is normal.of the freezer compartment and you may hear the
sound of water droplets coming into contact with
YLet the refrigerator run at least four hours before
adding food.the defrost heater. This is normal during the
defrost cycle.
Adjusting the TemperatureWarm Cabinet Surfaces
ControlsAt times, the front of the refrigerator cabinet may be
Y 24 hours after adding food, you may decide that onewarm to the touch. This is a normal occurrence that
or both compartments should be colder or warmer. Ifhelps prevent moisture from condensing on the
cabinet. The condition will be more noticeable when
so, adjust the control(s) as indicated in the followingyou first start the refrigerator, during hot weather and
table.after excessive or lengthy door openings.
Y Except when starting the refrigerator, do not change
either control more than one number at a time.
Y Allow 24 hours for temperatures to stabilize before
resetting.
Y Changing either control will have some effect on the
temperature of the other compartment.
5 |
ACEC
