FIRST WASH CYCLE
We recommend that the first wash cycle be carried out empty. This will remove any residual water used
in the factory checks.
1.Turn on the tap.
2.Close the drum flaps.
3.Pour a small amount of detergent (about 30 ml) into the detergent dispenser .
4.Select a short programme and low spin speed (see programme chart).
5.Switch on the appliance.
PRECAUTIONS AND GENERAL RECOMMENDATIONS
1.Packing3.Disposing of packaging and old appliances
? The packaging materials are 100% recyclable and ? The washing machine is built from reusable
bear the recycling symbol. Adhere to local materials. The washing machine must be
regulations when disposing of packaging material.disposed of in compliance with current local
waste disposal regulations.
2.Energy saving tips
? Achieve the best use of energy, water, detergent ? Before scrapping old machine, cut of the power cable
and time by using the recommended maximum so that the washing machine cannot be connected to
the mains.
load size.? Remove detergent from compartment if you
? Do not exceed the detergent dosages indicated
in the manufacturer?s instructions.intend scrapping your appliance.
? The Eco Ball - a special system in the outlet - will 4.Child safety
prevent detergent loss from the drum to avoid ? Children must not be allowed to play with or in
detergent loss into the environment.the appliance.
? Use ?Prewash? for heavily soiled laundry only! 5.General recommendations
Save detergent, time, water and energy ? Do not leave the appliance connected when not
consumption by not selecting ?Prewash? for in use. Turn off the tap.
slight to normally soiled laundry. ? Before cleaning or carrying out maintenance
? Pretreat stains with stain remover or soak dried switch off the washing machine and disconnect
in stains in water before washing to reduce the it from the mains supply.
necessity of a hot wash program.? To clean the outside of the washing machine,
? Save energy by using a 60° C instead of a 90° C use a neutral detergent and a damp cloth.
wash programme or a 40° C instead of a 60° C ? Do not use abrasive detergents.
wash programme.? Do not attempt to force the lid open.
? Save energy and time by selecting a high spin ? If necessary, the power cable may be replaced
speed to reduce the water content in laundry with an identical one obtained from our After-
before using a tumble dryer (for machines with Sales Service. The power cable must only be
adjustable spin speed).replaced by a qualified technician.
6.EC Declaration of Conformity
? This washing machine has been designed,
constructed and distributed in compliance with
the safety requirements of EC Directives:
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC CE Marking Directive
19 |
ACEC
