*Final spin results are poor.Water stop fault (depending on model).
Note: the washing machine has an unbalance (The pump operates).
detection and correction system. If individual The "Water Stop" fault may have been triggered by:
heavy items are loaded (a bathrobe, for example), Too much foam.
this system may reduce the spin speed
A leak in the inlet hose or in the washing
automatically or interrupt the spin if it detects too machine.
great unbalance at the start of the spin, in order to
Switch the washing machine off by pressing the
protect the washing machine. ?On/Off? button, unplug the washing machine
Excessive foam formation may also prevent and turn off the water tap.
spinning.Tilt the washing machine forwards carefully to
Check whether:allow the water to evacuate from the bottom tray.
the pump impeller is obstructed (see ?Cleaning
Reconnect the washing machine.
the foreign body trap?).Turn on water supply (if ?On/Off? button is not
if the laundry is still too wet at the end of the
programme: possibly add other items of clothing pressed, but the machine begins to fill, turn off the
water supply tap and contact After-Sales Service).
and repeat the spin cycle.
there is foam on the wash: repeat a rinse-spin Reselect the desired programme, add detergent, if
necessary, and press the ?On/Off? button to
cycle to eliminate excess of detergent.
restart the programme.
If the fault occurs again, contact After-Sales
Service (see ?After-Sales Service?).
29 |
ACEC
