FIRST WASH CYCLE
We recommend that the first wash cycle be carried out empty. This will remove any residual water used
in the factory checks.
1.Turn on the tap.
2.Close the drum flaps.
3.Pour a small amount of detergent (about 30 ml) into the detergent dispenser.
4.Press the ?On/Off? button.
5.Select a short programme (see programme chart).
6.Press the ?Start? button.
PRECAUTIONS AND GENERAL RECOMMENDATIONS
1.Packing3.Disposing of packaging and old washing
The packaging materials are 100% recyclable and machines
bear the recycling symbol. Adhere to local The washing machine is built from reusable
regulations when disposing of packaging material.materials. The washing machine must be
2.Energy saving tipsdisposed of in compliance with current local
Achieve the best use of energy, water, detergent waste disposal regulations.
and time by using the recommended maximum Before scrapping, cut of the power cable so that the
load size.washing machine cannot be connected to the mains.
Do not exceed the detergent dosages indicated Remove detergent from compartment if you
in the manufacturer?s instructions.intend scrapping your washing machine.
The Eco Ball - a special system in the outlet - will 4.Child safety
prevent detergent loss from the drum to avoid Children must not be allowed to play with or in
detergent loss into the environment.the washing machine.
Use ?Prewash? for heavily soiled laundry only! 5.General recommendations
Save detergent, time, water and energy Do not leave the washing machine connected
consumption by not selecting ?Prewash? for when not in use. Turn off the tap.
slight to normally soiled laundry. Before cleaning or carrying out maintenance
Pretreat stains with stain remover or soak dried switch off the washing machine and disconnect
in stains in water before washing to reduce the it from the mains supply.
necessity of a hot wash program. To clean the outside of the washing machine,
Save energy by using a 60° C instead of a 90° C use a neutral detergent and a damp cloth.
wash programme or a 40° C instead of a 60° C Do not use abrasive detergents.
wash programme. Do not attempt to force the lid open.
Save energy and time by selecting a high spin If necessary, the power cable may be replaced
speed to reduce the water content in laundry with an identical one obtained from our After-
before using a tumble dryer (for machines with Sales Service. The power cable must only be
adjustable spin speed).replaced by a qualified technician.
6.EC Declaration of Conformity
This washing machine has been designed,
constructed and distributed in compliance with
the safety requirements of EC Directives:
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC CE Marking Directive
20 |
ACEC
