3gb20077.fm Page 2 Wednesday, July 9, 2003 11:59 AM
?Half Load? button(depending on model)
CONSUMPTION DATATO INTERRUPT THE RUNNING PROGRAMME
? Reduces water consumption above all during
rinsing.To interrupt the running programme and continue
Temperature LoadWaterEnergyApprox.? Suitable for lightly soiled laundry and small it at a later time:
SelectorProgrammeloads (max 2.5 kg).
ProgrammeDuration1. Press the ?ON/OFF?button.
Note: reduce the detergent quantity.2. After the desired interval has passed, press the
(°C)(kg)(l)(kWh)(hours:minutes)
?ON/OFF?button again.
2 - Cotton90°3.5461.282:05DOOR LOCK
END OF WASH CYCLE
3 - Cotton60°3.5420.651:50The door locks automatically after the programme
3 - Cotton40°3.547.21.001:02start until the end of the programme. If the 1. At the end of the programme the programme
6 - Synthetics60°2.0460.681:12programme selector is moved to the ?Stop? selector moves to the ?Stop? position.
position or if the electricity supply is interrupted,
6 - Synthetics40°2.0460.341:032. To unload the machine wait for the door to
then after approximately two minutes the door is unlock (approx. 2 minutes).
7 - Wool40°1.0450.250:46released. In this case do not open the door,
3. Switch off the appliance, open the door and
Prewash cycle increases programme duration by approx. 15 minutes. Consumption data were measured in normalized because hot water could come out of the door.
conditions in compliance with Standard IEC 60 456. The data on the ?Energy Label? refer to programme ?Coloured Cotton unload the washing.
PROGRAMME RESELECTION4. Close the tap and leave the door ajar to allow
60° C?. Consumption data in the home may vary with respect to the values in the table in relation to the water supply
pressure and temperature, the load and the type of wash.To change a programme when a cycle has already the drum to dry out.
?Eco Wash? button(eco) begun:NOTES AND INDICATIONS FOR USE
ADD DETERGENT, CLOSE THE DOOR
(depending on model)AND SELECT THE PROGRAMME1. Switch off the appliance by pressing the
? Reduces the temperature to 60° when the ?ON/OFF?button.? SPIN SPEED CONTROL
Add the detergent as described in the programme thermostat is set to a higher temperature.2. Select the new programme.Spin speed may be reduced automatically or
table or in the chapter ?Detergent and Additives? in 3. Start the programme by pressing themay even be excluded in case of small loads
the booklet.?Rinse Hold? button(depending on model) containing highly absorbing garments (e.g.
in synthetic and wool programmes only?ON/OFF?button.
1. Make sure that the Programme selector is set to bath robes, towels, etc).
?Stop?.? The laundry remains in the last rinse water This reduces damage to fabric and to the
without progressing to the final spin cycle to
2. Open the tap.machine and prevents excessive vibration and
avoid creasing and prevent colours from noise in the machine due to an unbalanced
3. Set the programme selector to the desired changing.
programme.load: by selecting high spin speeds the noise
? This option is particularly recommended for the level increases.
4. Set the thermostat knob to the desired programme ?Synthetics? or ?Delicate?.? CLEANING THE FILTER
temperature.? This function is particularly useful if you want to
To ensure an impeccable function of the pump,
5. Set the spin selector knob to the desired speed.postpone spinning to a later time or when you do check the filter regular and clean it if
6. Special options can be selected, if required.not wish to spin the clothes.necessary.
7. Check that the door is well closed and turn on the To terminate the ?Rinse Hold? ? THERMOSTAT KNOB
washing machine by pressing the ?ON/OFF? option(depending on model)This is set by turning the knob until it reaches
button. The indicator lights up, indicating that in synthetic and wool programmes onlythe desired temperature.
the washing machine is on.? Press the Rinse hold button again; the load will
SELECT ANY DESIRED OPTIONbe spun according to the selected programme.
If you do not wish to spin the clothes, turn the
?Spin speed reduction? button
programme selector knob to the drain programme,
? Reduces the predetermined automatic maximum after pressing the ?No Spin? button.
spin speed.
In some programmes the maximum final spin
speed is limited to go easy on your laundry items.
Selection of a higher spin speed is not possible.
Whirlpool is a registered trademark of Whirlpool USA
5019 301 20077
Black process 45.0° 100.0 LPI |
ACEC
