?Rinse Hold? button
CONSUMPTION DATAPROGRAMME START
The laundry remains in the last rinse water
Temperature SelectorLoadWaterEnergyApprox. Programmewithout progressing to the final spin cycle to Open the tap and press the ?Start (Pause)?
button. The pilot lamp of the ?Start (Pause)?
ProgrammeDurationavoid creasing and prevent colours from
button lights up.
(°C)(kg)(l)(kWh)(hours : minutes)*changing.
This option is particularly recommended for the The indicator lamps show the sequence reached in
Cotton955.049**1.902:00
programme ?Synthetics?, ?Daily Load? and the programme. After starting the programme, the
Cotton605.0440.952:20sequence indication runs from left to right through
?Delicates?.
Cotton404.5440.602:05Wash, Rinse, Spin.
This function is particularly useful if you want to
Synthetics602.5550.801:30postpone spinning to a later time, or if you want When the sequence of the programme is finished
Synthetics402.5550.601:20to drain only.the corresponding lamp goes out.
Daily Load403.0450.501:00Note: The programme stops to ?Rinse Hold? at the
DOOR OPEN
time the ?Rinse Hold? light in the programme flow
Short303.0370.400:30
indication is on.The door can be opened when the ?End of cycle?
Delicates401.5600.600:45
Terminate the ?Rinse Hold? option:indication is on.
Wool301.0600.300:40
Press the ?Rinse Hold? button again; the
Handwash/Lingerie301.0450.300:40PROGRAMME END
programme will terminate automatically with the
Prewash might increase programme duration. Consumption values were measured in normalized conditions in final spin cycle for the present wash programme. The remaining time is on ?0:00? and all the lights
compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the If you do not wish to spin the clothes, turn the of the programme sequence indication are off.
table in relation to the water supply pressure and temperature, the load and the type of wash.programme selector knob counterclockwise to
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the 1. Turn the programme selector to the ??
the ?Drain? programme and press the ?Start
household conditions applicable at that time.(Pause)? button again when flashing.position.
**To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump 2. Turn the water supply tap off.
drains the water out.?Spin Speed Reduction? button
3. Open the door and unload the machine.
ADD DETERGENTS, CLOSE THE DOOR AND SELECT ANY DESIRED OPTION Every programme has an automatic predefined 4. Close the tap and leave the door ajar to allow
maximum spin speed.
SELECT THE PROGRAMMEthe drum to dry out.
Selecting any option the indication lights up. Press the button to set another spin speed.
Add the detergents as described in the programme When the combination of programme, If the spin speed ?0? is selected, the final spinning CHANGE THE PROGRAMME,
table or in the chapter ?Detergents and Additives? additional options and temperature is not
is cancelled but intermediate spin peaks remain TEMPERATURE, OPTIONS AFTER
in the booklet.possible, the indication lights switch off
during rinse. The water is drained out only.PROGRAMME START
automatically. Unsuitable combinations of
1. Turn the programme selector knob to the
options are deselected automatically.START DELAY1. Press the ?Start (Pause)? button to pause the
desired programme.
2. The remaining time display shows the duration ?Easy Ironing? buttonprogramme. The light flashes.
The ?Start Delay? allows to run the machine at the
of the chosen programme (in hours and 2. Select the new programme (with temperature),
Can be used together with ?Cotton?, consumer?s convenience, for example at night when
minutes) and the pilot lamp of the ?Synthetics? and ?Daily Load? programmes to electricity is cheaper.any options and another spin speed if you want.
?Start (Pause)? button is flashing.3. Press the ?Start (Pause)? button again. The
make ironing easier.
3. The programme sequence and the predefined Select programme, temperature and options.new programme continues at the same position
Increases the water quantity and the clothes are
spin speed indication corresponding to the Press the ?Start Delay? button to select the where the previous programme was interrupted.
spun very soft.
selected programme lights up.delay time by 1 to 23 hours;Do not add detergent for this programme.
The recommended temperature (see the ?Prewash? buttonPress the ?Start (Pause)? button.
indicator) can be altered by pressing ?+? or ?-? Only for heavily soiled loads (for example sand, The time delay indication disappears when the CANCEL A PROGRAMME BEFORE THE END
button.granular dirt) sensible. The cycle time increases programme starts and it is replaced by the
approximately 15 min.1. Press the ?Start (Pause)? button to pause the
remaining time.
?Intensive Rinse? buttonprogramme. The light flashes.
The number of hours preselected can later be
More water and a longer time in rinse cycle is reduced pressing again the ?Start Delay? button.2. Set the programme selector to ?Drain?. The
spin indicators show ?0? and the remaining
added.
To cancel the ?Start Delay?.time shows ?0:02?.
This option is particularly suitable for areas with
Turn the programme selector to the ? ? 3. Press the ?Start (Pause)? button to start the
very soft water, washing baby linen and helps
position.drain programme.
people with allergies.
Reselect the desired programme and options
and press the ?Start (Pause)? button.Whirlpool is a registered trademark of Whirlpool USA
5019 301 10214 |
ACEC
