7gb14811.fm Page 2 Tuesday, November 5, 2002 12:58 PM
BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check6.Electrical connections
? After unpacking, make sure that the washing ? Electrical connections must be carried out by a
machine is undamaged. If in doubt, do not use qualified electrician in compliance with the
the washing machine. Contact After-Sales manufacturer?s instructions and local safety
Service or your local dealer.regulations.
? Keep the packaging materials (plastic bags, ? Voltage information, power consumption and
polystyrene parts, etc.) out of reach of children, electrical fusing data are supplied on the front
since it is a possible source of danger.panel behind the door frame.
? The appliance must be connected to the mains
2.Remove the transit boltsexclusively by means of a socket with an earth
? The appliance is fitted with transit bolts to connection in accordance with established
prevent internal damage during transport. regulations. The appliance must be earthed by
Before using the washing machine you must law. The manufacturer declines all liability for
remove the transit bolts (see possible damage to property or injury to persons
?Installation/Remove the transit bolts?).or pets deriving from failure to observe the a/m
directions.
3.Install the washing machine? Do not use extension leads or multi sockets.
? Install the appliance on a solid and level floor ? Before any maintenance on the washing
surface. In the case of a yielding sub-floor, the machine disconnect the power plug or switch off
appliance should be installed in the corner of a the power supply.
room.? Access to the mains plug or to disconnection
? Adjust the feet to ensure that the machine is from mains supply via a double-pole switch must
stable and level on the floor (see be ensured at all times following the
?Installation/Adjust the feet?).installation.
? Do not operate the washing machine if it has
4.Water inletbeen damaged during transport. Inform the
? Connect the water supply inlet hose in After-Sales Service.
accordance with the regulations of your local ? Mains cable replacement is only to be carried out
water company (see ?Installation/Connect the
by After-Sales Service.
water inlet hose?).? This product is suitable for both domestic and
? Water supply: use hot and cold water
Semi professional use, and is guaranteed for 12
? Tap:3/4? BSP threaded hose months parts and labour for normal use.
connectionSemi Professional use is defined as suitable for
? Pressure: 100-1000 kPa (1-10 bar).use in small to medium sized establishments
such as Care & Nursing homes, Hairdressers,
5.Drain hosesheltered accomodation, Pubs, boarding houses,
? Connect the drain hose to the stand pipe, or health leisure & Sport clubs, vets & Stables etc.
ventilated siphon, or hook it over the edge of a In larger establishments you may need a full
sink by means of the ?U? bend (see commercial model, please always check with
?Installation/Connect the water drain hose?).your supplier who will advise on the correct
product for your particular application.
Both the Heavy Duty and Semi Professional
models comply with the UK Care Standard Act
2000 (CSA) Standard 26.
The warranty will not apply if the product is
being used in excess of these guidelines. |
ACEC
