30106020GB.fm Page 11 Wednesday, March 21, 2007 12:09 PM
Description of red indications
Red indicationRed indication
lights upon displayDescription
(if fitted on your (if fitted on your Causes
Solutions
machine)machine)
Appliance has no or insufficient water supply. The
?Start/Pause? light flashes.
Check whether:
Water tap is fully open and water supply pressure
is sufficient.
Kinks are present in the water inlet hose.
Mesh filter of water supply hose is blocked (see
?Care And Maintenance?.
The water hose is frozen up.
?Water tap closed?--- The safety valve inspection window of your water
supply hose is red (provided your appliance has a
water supply hose as shown on picture ?B? - see
previous chapter ?Care And Maintenance?);
replace the hose by a new one available through
our After-Sales Service or your specialist dealer.
After problem has been removed, restart
programme by pressing ?Start/Pause?. If the fault
occurs again, contact our After-Sales Service (see
next chapter).
Waste water is not pumped out. The appliance
stops in the corresponding programme step; unplug
it and check whether:
Kinks are present in the drain hose.
Filter or pump is blocked (see chapter ?Removing
The Filter/Draining Residual Water?; make sure
the water has cooled before draining the
?Clean pump?---appliance).
The drain hose is frozen up.
After problem has been removed, select and start
the ?Drain? programme or push the ?Reset? button
for at least 3 seconds; afterwards restart the desired
programme. If the fault occurs again, contact our
After-Sales-Service (see next chapter).
GB 11
Black process 45.0° 100.0 LPI |
ACEC
