3GB10288.fm Page 13 Tuesday, August 3, 2004 12:29 PM
*Final spin results are poor.Water stop fault (depending on model).
Note: the washing machine has an unbalance (The pump operates).
detection and correction system. If individual heavy The ?Water Stop? fault may have been
items are loaded (a bathrobe, for example), this triggered by:
system may reduce the spin speed automatically or ? Too much foam.
interrupt the spin if it detects too great unbalance at A leak in the inlet hose or in the washing machine.
?
the start of the spin, in order to protect the washing
Switch off the washing machine, unplug it and turn
machine.
off the water tap.
Excessive foam formation may also Tilt the washing machine forwards carefully to
prevent spinning.allow the water to evacuate from the bottom tray.
Check whether:
Reconnect the washing machine.
? the pump impeller is obstructed (see ?Cleaning
Turn on water supply (if the machine is switched
the foreign body trap?).
off, but begins to fill, turn off the water supply and
? if the laundry is still too wet at the end of the
contact After Sales Service).
programme: possibly add other items of clothing
and repeat the spin cycle. Reselect the desired programme, add the
detergent, if necessary and switch on the machine
? there is foam on the wash: repeat a rinse-spin
to restart the programme.
cycle to eliminate excess of detergent.
If the fault occurs again, contact After-Sales Service
(see ?After-Sales Service?).
GB 13 |
ACEC
