INSTALLATION INSTRUCTIONS
DRAIN HOSE
Drain hose connection to water outlet.
1. Unhook the drain hose from the right and left hose
connection, see A in figure.
Important:
Do NOT loosen the drain hose connection from the
clip on the left sBi de, sin figuee re, otherwise there is
the risk of leakage (danger of scalding with hot water).
2. Fix the ?U? bend supplied (inside the drum) to the
free end of the drain hose.
3. Fit the drain hose either to the siphon or hook it over
the edge of a sink or bath tu?Ub with the? bend.
Small hand basins are not suitable.
The edge of the tub must be no higher than 100
cm above the floor.
4. If you need to add an extension, use a flexible
hose of the same type and secure the unions with
screw-on hose clips.
Maximum overall drain hose length: 2.50 m.
Maximum drain heigh?tU (? bend): 100 cm.
Minimum drain height: 55 cm.
Important:
Make sure there are no kinks in the drain hose and
take precautions against it falling while the
appliance is running.
ELECTRICAL CONNECTIONS
Electrical connections must be made in accordance
with local regulations.
The appliance must be connected to the mains
exclusively by means of a socket with an earth
connection in accordance with established
regulations. The appliance must be earthed by law.
The manufacturer declines all liability for damage to
property or injury to persons or animals deriving
either directly or indirectly from failure to observe
the above directions.
The data of voltage, power consumption and the
required electrical protection are supplied on the
rear of the appliance.
The electrical power cable must be replaced, if
necessary, exclusively by a licensed electrician.
The appliance conforms to European safety
regulations, EC directive 93/68/EEC and
standard EN 60555.
Do not use extension leads or multisockets.
21 |
ACEC
