Note: The programme with ?Rinse Hold? stops when
CONSUMPTION DATAthe ?Rinse Hold? is indicated in the display.LID LOCK
Temperature LoadWaterEnergy Approx. ProgrammeAppliance in ?Rinse Hold?:For safety reasons, the lid is locked during certain
Selectorphases of the cycle. At the end of the cycle or during
ProgrammeDuration If you want to continue the programme press
(kg)(l)(kWh)(hours : minutes)*the ?Start/Pause? button again: The an interruption, the lid unlocks automatically after
(°C)
programme will terminate automatically with the about 1 minute.
Cotton / Hygienic955.049**1.602:05
Cotton605.0480.952:05selected spin cycle. If the load is dry then please END OF WASH CYCLE
press the ?Start/Pause? button.
Cotton + Eco plus***605.0480.852:15
If you do not wish to spin the load, turn the Upon programme end ?? is shown in the
Cotton405.0480.702:00programme selector knob to the ?Drain? display.
Synthetics602.055**0.801:30
programme and press the ?Start/Pause? button.1. Turn the programme selector to the ? ? position.
Synthetics402.0500.501:15
?Spin Speed Reduction? button2. Close the tap.
Daily Mixed403.0450.451:00 Every programme has an automatically allocated
Rapid303.0350.400:303.Open the lid and the door flaps and unload the
maximum spin speed.
Delicates401.5500.500:45appliance.
Press the button until you have reached the
Wool401.0550.600:45requested spin speed indicated in the display.CHANGE THE PROGRAMME OR OPTIONS
Handwash / Lingerie301.0400.400:35DURING THE CYCLE
If the spin speed ?0? is selected, the final spin is
Prewash cycle might increase programme duration. Consumption values were measured in normalized conditions in compliance cancelled, but not the intermediate spins. The
with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the Press ?Start/Pause? button. Select new
water supply pressure and temperature, the load and the type of wash.programme ends with a drain cycle.
*The remaining time indicator can similarly deviate from the values in the table, because it takes into account the programme and/or new options, temperature and
household conditions applicable at that time.START DELAYspin speed and press ?Start/Pause? button again.
** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump The new programme will continue at the same
drains the water out.The ?Start Delay? button allows the user to run
*** Reference Programme for Energy Label.the appliance at his convenience, for example at position where the previous programme was
PREPARATION OF WASH CYCLE?Easy Ironing? buttonnight when electricity is cheaper.interrupted. Do not add detergent for this
1. Close the drum door flaps and check that they Can be used together with ?Cotton?, ?Synthetics? and Select programme, temperature and options.programme.
?Daily Mixed? programmes to make ironing easier.
are properly locked. Press the ?Start Delay? button several times to Note: The ?Start Delay? and ?Prewash? cannot be
2. Add detergents and additives into the dispenser to Increases the water quantity in rinsing and the select the delay time by 1 to 24 hours (selected
selected after a programme change.
no more than the ?MAX? level mark, as follows:clothes are spun in a softer manner.delay is indicated in display);
?Eco plus? buttonPAUSE/INTERRUPT A PROGRAMME
Programme with pre and main washPress the ?Start/Pause? button. The indicator
With a modified temperature profile and a slightly
Main wash programme without prewashprolonged washing duration, the optimum light of the ?Start/Pause? button lights up, the If, for adding some forgotten pieces of clothing or any
Fabric softeners and conditionerscombination of excellent washing result and even lamp of the ?Start Delay? button flashes and the other reasons, you wish to interrupt or pause the
Chlorine bleachlower energy consumption can be achieved.selected delay is indicated in the display.programme for a certain time and continue it later:
The time delay indication disappears when the
Stain remover agents?Prewash? button1. Press the ?Start/Pause? button.
programme starts and is replaced by the
Anti-scale agents (if necessary) Only for heavily soiled loads (for example mud, remaining time.The light flashes.
3. Turn the programme selector knob to the granular dirt).
The number of hours preselected can be reduced 2. After the desired pause, press again on the
desired programme. ?Intensive Rinse? button
later by pressing the ?Start Delay? button again.?Start/Pause? button.
The remaining time of the chosen programme is The amount of water is increased to ensure a To cancel the pre-selected ?Start Delay?
shown in the display (in hours and minutes) and the more intensive rinse.CANCEL PROGRAMME
Turn the programme selector to the ? ? position.
indicator light of the ?Start/Pause? button flashes. This option is particularly suitable for areas with To cancel a programme please press Reset Button
The predefefined temperature & spin speed very soft water or washing linen laundry for Reselect the desired programme and options
people with skin allergies.and press the ?Start/Pause? button.for 3 seconds.
corresponding to the selected programme are
indicated in the display. The temperature (+/-) ?Rinse Hold? buttonNote: After power cuts or disconnection from the PROGRAMME START
and spin speed can be changed by pressing The laundry remains in the last rinse water mains after programme end, the LCD display may
without progressing to the final spin cycle to Open the tap and press the ?Start/Pause? button.
the corresponding button.show the previously selected settings. In this case we
avoid creasing from fading.The indicator light of the ?Start/Pause? button lights suggest to check laundry?s humidity in drum.
SELECT THE DESIRED OPTION This option is particularly recommended for the up. At programme start the sequences reached by the If laundry is damp, the cycle finished properly. Unload
When you select an option authorized by the ?Synthetics?, ?Delicates? and ?Daily Mixed? programme are indicated in the display.the drum and press Reset Button for 3 seconds
programme, the corresponding indicator lights up, programmes.Note: If there's a power cut during the cycle, the before selecting a new cycle for next laundry.
except if the combination of programme, Use this option if you want to postpone spinning programme will continue automatically from where
additional options and temperature is not possible.to a later time, or if you want to drain only.it was interrupted.Whirlpool is a registered trademark of Whirlpool USA
5019 312 10383 |
ACEC
