ELECTRICAL CONNECTION
2.2 Non-polarized plugs (e.g. 2 pin with side
1) ELECTRICAL CONNECTIONS
earth contact)
?Warning - this appliance must be The wire which is coloured GREEN AND
earthed?
YELLOW must be connected to the earth
This appliance is normally supplied with a contact. The other two wires should be
mains lead having a plug fitted in the factory connected to the two pins, irrespective of
which has been checked for correct earth colour.
continuity.
If the fitted plg is not suuitable for your soc3) FUSEket REPLACEMENT
outlet, or if the machin?s mains leead is not If the mains lead of this appliance is fitted with
fitted with a pg, you shluould fit a suitable new,
a BS 1363A 13 amp fused plug, replace the
good quality g by plu followg ithe innstructions in fuse only with an A.S.T.A. approved type
(2) below.
conforming to BS 1362 and proceed as follows:
Any unsuitable plug should be cut off and
disposed of in order to avoid a possible shock
hazard should it be inserted into a socket.
2) CONNECTION TO A REWIRABLE
PLUG - to be carried out only by a
qualified electrician
The wires in the mains lead are coloured in
accordance with the following code:
BLUE - ?NEUTRAL ? (?N?)
BROWN - ?LIVE? (?L?)
GREEN AND YELLOW - ?EARTH ? (?E?)
To fit a new pg, proclu eed as follows:
2.1 Polarized Plugs (eg.. 3 pin, 13 amp plug
conforming to BS 1363A)1. Remove the fuse covAe) and ther ( fuse
a. The GREEN AND YELLOW wire must be (B).
connected to the terminal ing wh the pluich 2. Fit the replacement 13 A fuse into the fuse
is marked with the letter ?E? or by the Earth
cover.
symbol or coloured yellogreenw or and 3. Refit both into the plug.
yellow.
For all other types of pg, the supply socluket
b. The BLUE wire must be connected to the should be protected by a 16 A fuse or circuit
terminal which is marked with th?N? e letter
or coloured black.breaker at the distribution board.
c. The BROWN wire must be connected to the
terminal which is marked with the?L? letter
or coloured red.
17 |
ACEC
