INSTA ATION
OWNER: Keep these instructions for future
INSTALLER: Leave these instructions with
the appliance. use.
Place the bottom of the template on a level base line,1 6-112?
TOOL LIST above the floor. This will position the open upper oven door
about 37? above the floor.
1 l/8? drill bit
It is important that the oven be installed at or above the
2. Electric or hand drill
minimum height specified. The unit has been tested and
3. Flat bladed screwdriver
approved in accordance with safety standards at this height.
4. No. 1 or No. 2 Phillips screwdriver The oven vent area may get hot when the oven is in use.
5. Pencil Following these installation instructions will move the vent
area out of a range where it would likely be touched by small
6. Ruler and straight edge
children.
7. Hand saw or saber saw
8. Pipe wrench The cabinet must have a solid bottom. This solid bottom may
either be at the floor or 16-l/2? above the floor, level with the
9. 518? wrench and l/2" wrench or adjustable wrench
bottom edge of the cutout opening. If the solid bottom is to
be at the floor, two runners, centered within the cabinet and
LOCATION 11? apart may be used to support the oven. Be sure the oven
support is solid enough to hold the weight of the unit - about
Cabinet space, with 5 solid sides must be provided to
200 pounds. Also, be sure the support is level and straight.
completely enclose the recessed part of your built-in oven
There is no way to level the oven after installation.
except for the vent thimble on outside vented units. See
Figure 1 for all necessary dimensions. A cutout 22? wide by Drafts inside the oven cabinet may affect safe use of your
50-l/4? high must be made in the cabinet front. It is best to oven. Any openings around gas and electric service outlets
make a template to insure accurate cutting. may be sealed at the time of installation to prevent drafts.
OVEN AND CUTOUT
DIMENSIONS
24' A 24'
Fig. 1
GINS691
lNT026(342461)-1 |
ACEC
