6. Place charcoal briquettes randomly throughout
newspaper.
!CAUTION
7. Close doors and let stand 24-48 hours.
8. Remove charcoal briquettes and newspapers.To avoid personal injury or property damage, observe
9. Complete steps 2-3.the following:
Contact Consumer Affairs Department if odor was still not Allow light bulb to cool.
eliminated. Wear gloves when replacing light bulb.
Adhesives Remove light bulb cover by removing 1" hex nut
1. Remove glue residue by rubbing toothpaste intoscrews. Replace with appliance bulb no greater
adhesive with fingers until adhesive loosens.than 60 watts.
2. Rinse surface with warm water. Dry surface with a Replace light bulb cover by replacing 1" hex nut
soft, clean cloth.screws.
Door Gaskets
A
1. Clean door gaskets as necessary according to
General instructions. Gaskets must be kept clean
and pliable to assure proper seal.
2. Apply a light film of petroleum jelly on hinge side of
gasket to keep gaskets pliable.
Condenser Coils
Clean condenser coil every 3 months to ensure maximum
performance of refrigerator. Accumulated dust and lint
may cause the following:
B
reduced cooling performance
A 1" hex nut screwsB Light bulb cover
increased energy usage
premature part failure
Energy Tips
1. Remove toe grille by holding ends and pulling
forward.This refrigerator is designed to be one of the most energy
2. Clean front surface of condenser coil with a vacuumefficient refrigerators available. Reduce energy use by
cleaner hose nozzle.observing the following.
3. Replace toe grille by inserting clips in holes and Operate in normal household temperatures of 55° to
snapping in.110°F (13°C to 43°C) away from heat sources and
direct sunlight.
Glass Shelves Set Fresh Food, Deepfreeze?, and drawer controls
no colder than necessary.
?
Keep Deepfreeze section full.
!CAUTION
Keep door gaskets clean and pliable. Replace
To avoid personal injury or property damage, handlegaskets if worn.
tempered glass shelves carefully. Shelves may break
Keep condenser coils clean.
suddenly if nicked, scratched, or exposed to sudden
temperature change.Vacation Tips
Remove shelf by lifting front, releasing hooks from metalComplete the following steps for short vacations.
track then pulling out. Place shelf on a towel. Allow shelf
1. Remove perishable foods. Warranty does not cover
to adjust to room temperature before cleaning.
food loss. Check warranty certificate for specific
Clean crevices by completing the following steps:coverage.
1. Dilute mild detergent and brush solution into crevices2. If an ice maker is installed, move ice maker arm to
using a plastic bristle brush. Let set for 5 minutes.off position.
2. Spray warm water into crevices using faucet spray
Complete the following steps for long vacations.
attachment.
1. Empty Fresh Food and Deepfreeze? sections.
3. Dry shelf thoroughly and replace shelf by inserting
2. Unplug refrigerator.
hooks into metal track and lowering front.
3. Clean refrigerator and door gaskets according to
Light BulbsGeneral instructions in Care and Cleaning section.
4. Prop doors open, so air can circulate inside.
5. If an ice maker is installed, turn water supply to
!WARNING
refrigerator off and move ice maker arm to off
To avoid electrical shock which can cause severeposition.
personal injury or death, disconnect power to
refrigerator before replacing light bulb. After replacing
light bulb, connect power. |
ACEC
