Installation Instructions
Proper installation will ensure this refrigerator operates? Turn stabilizing leg (some models) clockwise until
most efficiently.firmly against floor.
Space Requirements
Roller
! WARNING
adjustment
Keep flammable materials and vapors, such asscrew
gasoline, away from refrigerator. Failure to do so can
result in death, explosion, fire, or burns.
? To ensure proper ventilation for your refrigerator, allow
for a 1? (2.5 cm) space at the top of your refrigerator.
? If your refrigerator has an ice maker, make sure youStabilizing leg
Bottom hinge
leave some extra space at the back to allow for the(some models)
cover
water line connection. The refrigerator can be flush
with the back wall if you do not have an ice maker
installed.Door Reversal
? If you are installing your refrigerator next to a fixed
Tools Required
1
wall, leave 2 /2" minimum on each side (depending on
Putty knife (blade covered by masking tape)
your model) to allow for the door to swing open 90°.5
/16" hex nut driver
3
/8" hex nut driver
NOTE: Do not install the refrigerator near an oven,
Phillips screwdriver
radiator, or other heat source, nor in a location where the
Blade screwdriver
temperature will fall below 55°F (13°C).
Some installations may require door reversal to achieve
Leveling Refrigeratorfull door swing. To reverse door swing direction perform
the following steps:
Some installations may require door reversal to achieve
full door swing. If so proceed to "Door Reversal" section
1. Remove and reverse refrigerator and freezer handles.
before leveling your refrigerator.
IMPORTANT: To prevent scratching of refrigerator
If your refrigerator requires ice maker water supply
surfaces, blade of screwdriver and putty knife called for in
connection, proceed to ?Connect ice maker water supply?
steps below must be covered with masking tape.
section on page 7 before to leveling your refrigerator.
Refrigerator
1. Plug in power cord.
? Pry up end caps using a putty knife with the blade
2. Move refrigerator into final location.
covered with masking tape. Remove end caps from
3. Level refrigerator using a level placed on top of the
refrigerator door. Remove handle from door by
refrigerator.
removing 2 mounting screws at each end of handle.
? Remove toe grille. Remove bottom hinge cover if
? Nameplate logo will automatically reverse.
refrigerator has a stabilizing leg.
3
? Turn /8" hex headroller adjustment screws to raise
or lower refrigerator cabinet. Front of refrigeratorRefrigerator
11
must be /4" (6 mm), or /2 bubble on your level,door
higher than the back of your refrigerator.
Handle
? Make sure refrigerator cabinet is level from side to
side by adjusting left and right roller adjustment
screw.
End
caps
Handle
screws
4 |
ACEC
