a. Remove top hinge cover. Remove top hinge.4.Level refrigerator.
Remove and retain all shims.a. Remove toe grille.
b.Remove fresh food door.b. Turn roller adjustment screws right to raise
c. Remove and retain all shims. Remove centercabinet, and left to lower cabinet.
hinge pin.c. Turn roller adjustment screw to raise or
d. Remove freezer door. An internal support rodlower front of refrigerator.
may slide out. Replace rod before hanging door.
e. Remove center hinge bracket.d. Adjust stabilizing leg to support
f.Remove toe grille.refrigerator firmly against floor.
!CAUTION!CAUTION
To avoid personal injury or property damage caused
To avoid property damage, protect soft vinyl or otherby refrigerator tipping, stabilizing leg must be firmly
flooring with cardboard, rugs, or other protective
material when moving refrigerator.against floor.
g. Slide appliance cart under side of refrigerator.
Wrap refrigerator with blanket or pad. Thread cart
strap around refrigerator and tighten. Do not
overtighten strap. Move refrigerator in front of
final location.
h. Reverse doors if necessary.A
? Replace internal support rod in hinge side of
freezer door before hanging door.
? Reverse door stops.B
A
C
A Rear roller adjustmentC Stabilizing leg
B Front roller adjustment
A Support rod
? Exchange hinge pin from bottom hinge assembly
with outward hinge plug from opposite bottom
hinge assembly.
i.Rehang doors by reversing steps a-f.
? Space door 18 mm from cabinet.
? Handle side of door should be approximately
3 mm higher than hinge side.
11/16"
(18 mm)
2.Plug in power cord.
? This equipment, including power cord, must be
serviced only by qualified service personnel.
Special tools are required to service equipment.
Contact nearest authorized service facility for
examination, repair or adjustment.
3.Move refrigerator into final location.
3 |
ACEC
