PROBLEM CHECK IF CAUSES/SOLUTIONS
shrlnklng Items are overdried Remove items while there is still a trace
of moisture. Some items should be
removed while damp, then shaped and
alr dried.
Fabric type and quality is Some knits are stretched during manufac-
suitable for drying turfng. Washing and drying returns them
to the original size. This is normal. Check
quality of garment before buying. Follow
fabric care label directions carefully.
Slow drying There is a large amount of Some items hold more moisture than
moisture in the load to be others (cottons more than polyester).
dried They take longer to dry. Full loads take
longer to dry than small loads of the same
fabric.
Cofd rinse water is used A load rinsed in cofd water will take
slightly longer to dry than a warm one.
Cold rinses, however, help save energy
and reduce wrinkling more than warm
rinses do.
Room air temperature is Install dryer in a room where the air
below 45°F (7°C) temperature is warmer than 45°F (7°C).
Cold air increases drying time and may
cause wrinkles not to be removed.
Dryer is exhausted according Install and exhaust your dryer according
to Installation Instructions to the Installation Instructions provided.
Lint screen is full Clean lint screen before or after
each use.
Exhaust duct or outside Clean if needed.
exhaust hood is clogged
Proper electrical supply is Properly connect the dryer to a grounded
used electrical circuit that meets the electrical
requirements stated in the Installation
Instructions.
Statk Load is overdrfed Remove items while there is still a trace
l ctrklty of moisture.
Fabric softener is used Use a fabric softener and follow package
directions carefully.
Synthetics, synthetic blends, Synthetics, synthetic blends, permanent
permanent press and knits are press and knits build up static electricity.
in load Use a fabrii softener and be careful not
to overdry the load.
17 |
ACEC
