6. The ice maker is equipped with a built-in water strainer. If your
water conditions require a second water strainer, install it in Complete the Installation
the 1D?" (6.35 mm) water line at either tube connection. Obtain
a water strainer from your nearest appliance dealer.
Style 2WARNING
1. Unplug refrigerator or disconnect power.
2. Remove and discard the shipping tape and the black nylon
plug from the gray, coiled water tubing on the rear of the
refrigerator.
3. If the gray water tube supplied with the refrigerator is not long
enough, a 1D?" x 1D?" (6.35 mm x 6.35 mm) coupling is needed in
order to connect the water tubing to an existing household
water line. Thread the provided nut onto the coupling on the Electrical Shock Hazard
end of the copper tubing.
Plug into a grounded 3 prong outlet.
NOTE: Tighten the nut by hand. Then tighten it with a wrench
two more turns. Do not overtighten. Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
ABCDEFG
1. Plug into a grounded 3 prong outlet.
A.Refrigerator water tubingE.Ferrule (purchased)
B.Nut (provided)F.Nut (purchased)2. Flush the water system. See ?Prepare the Water System? or
C.BulbG.Household water line?Water and Ice Dispensers.?
D.Coupling (purchased)NOTE: Allow 24 hours to produce the first batch of ice. Allow
4. Turn shutoff valve ON.3 days to completely fill ice container.
5. Check for leaks. Tighten any nuts or connections (including
connections at the valve) that leak.
REFRIGERATOR USE
Style 3
1. Unplug refrigerator or disconnect power.
2. Remove and discard the shipping tape and the black nylon Using the Controls
For your convenience, your refrigerator controls are preset at the
plug from the gray, coiled water tubing on the rear of the factory. When you first install your refrigerator, make sure that the
refrigerator.
3. Thread the provided nut onto the water valve as shown.controls are still preset. The Refrigerator Control and the Freezer
Control should both be set to the ?mid-settings.?
NOTE: Tighten the nut by hand. Then tighten it with a wrench
two more turns. Do not overtighten.
AIMPORTANT:
BYour product will not cool when the REFRIGERATOR Control
is set to OFF.
The Refrigerator Control adjusts the refrigerator compartment
temperature. The Freezer Control adjusts the freezer
compartment temperature. Settings to the left of the mid-
setting make the temperature less cold. Settings to the right of
A.Bulbthe mid-setting make the temperature colder.
B.Nut (provided)
Wait 24 hours before you put food into the refrigerator. If you
4. Turn shutoff valve ON.add food before the refrigerator has cooled completely, your
5. Check for leaks. Tighten any nuts or connections (including food may spoil.
connections at the valve) that leak.NOTE: Adjusting the Refrigerator and Freezer Controls to a higher
(colder) than recommended setting will not cool the
compartments any faster.
5 |
ACEC
