Installation (cont?d)
Range has been grounded at the factory to the centerInstalling 3-Wire Power Cord
(nickel plated) terminal of the terminal block inRefer to power cord instructions if available for additional
accordance with the National Electrical Code (sectioninformation.
2560). When a separate ground is required by local code,1. Remove wire cover on rear of range.
disconnect the grounding strap from the terminal block.2. Place strain relief (winged clamp) in cord access hole
Ground frame by connecting a grounding wire to rangebelow terminal block.
frame using only the grounding screw removed from the? Strain relief is supplied with cord. Place wings
grounding strap.through hole, entering from bottom. Screw holes in
clamp should be below mounting panel. Place cord
Neutral termincaonnecl t wirethrough strain relief.
with white insulation 3. Attach neutral (center) or white wire to center terminal
on terminal block.
Power terminals
4. Attach power lead, red wire or black wire, to left side
(240 V)
power terminal.
5. Attach power lead, red wire or black wire, to the right
side power terminal.
6. After wires have been placed on terminals, attach with
hex nuts provided.
? Firmly tighten to ensure proper electrical
connection.
Ground
7. Place screw through strain relief and tighten.
strap
8. Replace rear wire cover.
Power leadc onnect wire
with black or red insulationWires from range
and brass terminal(Number of wires on each terminal can vary)
Range Terminal Block
AB
A
Terminal block is approved for copper wire connection
only, NOT aluminum wiring. If aluminum house wiring
is to be connected, the following procedure is suggested.
1. Connect length of copper building wire to range
terminal block with ring terminals.
2. Splice copper wires to aluminum wiring using
connectors which are design certified by Underwriter?s
Laboratories and recognized for joining copper to
aluminum. Follow the connector manufacturer?s
recommended procedure.
3. Wire used, location and enclosure of splices must
conform to local codes.Wires from power cord
A? Power lead terminal (Connect black or red insulated wire
and secure with brass nut.)
B? Neutral terminal (Connect insulated white insulated wire and
secure with brass nut.)
3-Wire Power Cord
8 |
ACEC
