REMOVABLE KNOBS
Al control knobs may be removed for easy cleaning by pulling the knob
straight off !he sierl See the cleaning InstructIons on page 11
HIit Slip a thin cloth (such as a handkerchlefl or a piece of string under
arc1 around the knob edge and pull up
SEE. the cleaning InstructIons on page 11
Caution: Read lhese instructions carefully before replacmg the knobs.
Replacing the knobs improperly will damage the knobs and the spring
clip on Ihe stems. if this happens, the knobs will fit loosely.
To correctly replace the knob:
1 Look at the stem It has a groove in each side The groove IS clear
(see illustratron)
2 Check the InsIde of the knob and find the molded rrb
3 Replace the knob by frttrng the molded nb rnsrde the knob Into the
clear groove on the slem
REMOVABLE COOKTOP UNITS
The cooktop elements of open co11 element models can be unplugged and
the reflector bowls removed for cleanrng Important: Never operate a cooktop element without the reflector bowl
in place This can cause scorching of the cooktop. burning of wirmg
Be sure all cooktop unit control knobs are turned off and elements are Insulation and loss of energy.
cool before you remove or replace a cooktop unit.
To remove:
1, Grasp element trlt 11 upward slrghtly to clear the refleclor bowl, then
pull away from the receptacle The element will not sit level when
replaced if it is forced too far upward when removed.
2. Lift out the reflector bowl. See the cleaning instructions on page 11.
DO not put the element into water, It cleans itself when heated dur-
ing normal use
To replace:
1 Replace the reflector bowl Be sure the receptacle IS showmg In the
bowl opening
2. For models with porcelain enameled reflector bowls, replace chrome
tnm ring.
3 Slide the plug of the element firmly rnto lhe receptacle and lower the
element Into place. |
ACEC
