Connecting your portable dishwasher
A special adapter must be installed on the faucet before the dishwasher can
be connected. Complete instructions and the adapter are packed with your
dishwasher.
When moving your dishwasher, make sure ing down the locking collar. Pull down on
the door is latched. Use the built-in pull bar or the connector.
hold it at the top front corners, 4. Empty any remaining water from the
connector.
5. Unplug power supply cord and return to
storage compartment.
6. Return hoses to storage compartment.
Electrical Connection
A power supply of 120 volts, 60Hz AC only, 15
amps, is required. For your personal safety, this
appliance must be grounded. This appliance
Before
is equipped with a power supply cord having
I. Run water at faucet until it is hot. Turn it off. a 3-prong grounding plug. To minimize possi-
ble shock hazard it must be plugged into a
mating J-prong grounding type wall recepta-
cle, grounded in accordance with the Na-
tional Electrical Code and local codes and
PULL RING ordinances. If a mating wall receptacle is not
available, it is the personal responsibility and
2. Pull hoses out of their storage compartment
obligation of the customer to have a properly
on the back.
grounded J-prong wall receptacle installed
by a qualified electrician. DO NOT use an ex-
tension cord.
(?$LK?z~i u
?I-
?4
91 j 0
i-.
I 1
3. Pull down on the locking collar while lifting ?Qj- /
3:
the hose connector onto the faucet adapter.
4. When the connector snaps into place, re- Power Supply Cord
lease the locking collar.
DO NOT, UNDER ANY CIRCUMSTANCES, RE-
5. Turn the hot water on slowly until it is all the MOVE THE POWER SUPPLY CORD GROUND
way on. PRONG.
6. Plug in power supply cord.
7. See pages 8 and 9 to start the dishwasher. Converting to built-in
Your Whirlpool Portable Dishwasher can be
While dishwasher is running
converted to a built-in (undercounter) model
You can draw water from the faucet while the by using conversion kit No. 569056. The kit is
dishwasher is connected. DO NOT draw water available at your Whirlpool dealer or autho-
while the dishwasher is filling or while water is rized TECH-CARE? Service Company. Instruc-
being pumped out. (This helps prevent a low fill tions are included with the kit.
when dishwasher is filling, or mixing drain water
with fresh water.)
Caring for
1. Press red button on hose connector to get
the water you want. [The faucet is set on hot. simulated wood top
Adjust faucet for the water you want.)
The simulated wood top can be used as a
2. Be sure you return cold water to off, and utility work surface for most kitchen jobs. It is
that hot water is full on. stronger and more easily cleaned than genu-
ine wood.
When cycle is finished
The top can be used as a cutting board. Knife
1. Turn hot water off (This can be done after the marks will be visible but will not seriously dam-
last rinse.) age top. Hot items from the oven can be placed
2. Press the red button on the connector to re- on the top.
lease the water pressure. Clean with warm, soapy water. For dried on
3. Lift slightly on the hose connector while pull- foods, use a scouring pad.
14 |
ACEC
